User manual DREAMGEAR 11 IN 1 MEGA BUNDLE

[. . . ] To remove the controller, push the controller from the hole located on the back of the Shield. How to Insert the PlayStation Move motion controller into the Archery Bow: 1. NOTE: Before inserting the PlayStation Move motion controller into any extension or accessory, please make sure that you sync the controller to your PlayStation system first. [. . . ] To release the extension from the Remote Cradle, hold down the latch on the front of the Remote Cradle and turn the extension clockwise and pull off the Remote Cradle. NOTE: Do not use the extension if it does not lock into place. How to Insert the PlayStation Move motion controller into the Shield: NOTE: Make sure that the wrist strap that is included with the PlayStation Move motion controller is being used. Please refer to the PlayStation Move motion controller's User's Guide on how to install the wrist strap onto the controller. Slide the Release Button located on both sides of the Motion Blaster towards the back of the blaster (see Image A1). Line up the directional and Menu buttons with the intended holes on the Archery Bow as shown in Image B. Insert the PlayStation®MOVE motion controller or navigation controller into the elastic holders on each glove. To charge an original PlayStation Move motion or navigation controller, place the controller onto the correct port. Make sure that the bottom of the controller is aligned with the mini-USB plug on the controller plug. The LED charge indicator will turn RED when charging and BLUE when fully charged. NOTE: When the controller or device is about 95% charged, the LED charge indicators will flash between a RED and BLUE LED. Once fully charged, the LED charge indicator will light solid BLUE. NOTE: You can charge up to 2 DualShock3 or SIXAXIS controllers, 1 PlayStation Move motion controller, 1 PlayStation Move navigation controller and 2 other USB devices (with the 2 USB ports) simultaneously. Make sure that the Quad Dock Pro is powered OFF when not in use. ⷠ2 USB ports are located on the back of the Quad Dock Pro to charge other devices such as a headset or keypad. Please refer to the User's Guide of each device for charging times and charging instructions. [. . . ] To remove the PlayStation Move motion controller from the Motion Blaster, simply follow steps 1 and 2. Once the steps are completed, hold the controller at the top and pull up. Plug the included 110/240 volt AC adapter into the DC port located on the back of the Quad Dock Pro. [. . . ]