User manual DREMEL 750

[. . . ] Use of these devices can reduce dust related hazards. Do not use any adapter plugs with earthed (grounded) power tools. Avoid body contact with earthed or grounded surfaces such as pipes, radiators, ranges and refrigerators. There is an increased risk of electric shock if your body is earthed or grounded. [. . . ] Water entering a power tool will increase the risk of electric shock. Never use the cord for carrying, pulling or unplugging the power tool. Keep cord away from heat, oil, sharp edges or moving parts. When operating a power tool outdoors, use an extension cord suitable for outdoor use. Use of a cord suitable for outdoor use reduces the risk of electric shock. Use the correct power tool for your application. The correct power tool will do the job better and safer at the rate for which it was designed. Do not use the power tool if the switch does not turn it on and off. Any power tool that cannot be controlled with the switch is dangerous and must be repaired. Disconnect the plug from the power source before making any adjustments, changing accessories, or storing power tools. Such preventive safety measures reduce the risk of starting the power tool accidentally. No matter how you use your Dremel electric engraver, you'll do a professional-like job by following these simple operating instructions. In order to use your engraver, you must first install the engraver point. To remove a worn out engraver point, loosen the set screw and remove the engraver point (figure 1). Replacement engraver points may be purchased from your Dremel dealer. Before plugging in the tool, be certain that the outlet voltage you are using matches the voltage number marked on the back label (name plate label) that is located on the engraver. To use the engraver, turn the engraver "ON" by moving the on/off switch located at the end of the tool (figure 2). hold the engraver at a slight angle as you would normally hold a pencil. Hold the unit lightly while resting your arm comfortably on a table. Use a light touch guiding the point over the work somewhat slower than you would normally write. It is not intended to be used as an "OFF" switch. A good "rule of thumb" is to select the lowest setting which will produce a deep enough engraving mark to meet your requirements. [. . . ] A good "rule of thumb" is to select the lowest setting which will produce a deep enough engraving mark to meet your requirements. To familiarize yourself, experiment with different settings on scrap materials. NOTE: The "lowest" position of the adjusting knob will be with the knob pointing to the number "1" on the housing. With extended use, the positive detent indicator associated with the depth control knob will begin to wear down and be less noticeable. [. . . ]