User manual DREMEL 800

[. . . ] Properly maintained cutting tools with sharp cutting edges are less likely to bind and are easier to control. Use the power tool, accessories and tool bits etc. , in accordance with these instructions and in the manner intended for the particular type of power tool, taking into account the working conditions and the work to be performed. Use of the power tool for operations different from those intended could result in a hazardous situation. [. . . ] Use of a cord suitable for outdoor use reduces the risk of electric shock. If operating a power tool in a damp location is unavoidable, use an earth leakage circuit breaker. Use of an earth leakage circuit breaker reduces the risk of electric shock. Have your power tool serviced by a qualified repair person using only identical replacement parts. This will ensure that the safety of the power tool is maintained. Stay alert, watch what you are doing and use common sense when operating a power tool. Do not use a power tool while you are tired or under the influence of drugs, alcohol or medication. A moment of inattention while operating power tools may result in serious personal injury. Safety equipment such as dust mask, non-skid safety shoes, hard hat, or hearing protection used for appropriate conditions will reduce personal injuries. Ensure the switch is in the off position before plugging in. Carrying power tools with your finger on the switch or plugging in power tools that have the switch on invites accidents. P rotectyourselfagainsttheeffectsofvibrationbymaintaining the tool and its accessories, keeping your hands warm, and organizing your work patterns. Rotate the rotary tool so the shaft lock button can be operated through an opening in the tool holder. apply the shaft lock button and loosen the router bit. Remove the router bit through the table and install another router bit. ATTENTION: Read entire instruction manual carefully before using your DremelShaper/RouterTable. Depth of cut will be the amount the bit extends above the shaper/router table. seeFigure4: A Large Knob B Depth of Cut C Table D Depth Adjustment Screw E ToolHolderAssembly Adjustment markings on the side of the tool holder facing outward are marked in inches and millimeters. View the markings prior to starting yourproject. turnthedepthadjustmentknobtosetdesireddepth. To ensure proper settings, rout and measure cut on scrap material. Forbestcontrolandqualityofcut, feedthework into the bit in the direction that the bit will tend to pull the work to the fence. [. . . ] ThisDREMELproductisguaranteedinaccordancewithstatutory/ country-specific regulations; damage due to normal wear and tear, overload or improper handling will be excluded from the guarantee. In case of a complaint, send the tool undismantled together with proof of purchase to your dealer. Center cylinder of the guard can be adjusted up when making cuts using the fence. loosen thumb nut , lift the cylinder up and secure by tightening thumb nut. [. . . ]