User manual DSC ESCORT V1.0

[. . . ] INSTRUCTION MANUAL SOFTWARE VERSION 1. 0R FCC COMPLIANCE STATEMENT CAUTION:Changes or modifications not expressly approved by Digital Security Controls Ltd. could void your authority to use this equipment. This equipment generates and uses radio frequency energy and if not installed and used properly, in strict accordance with the manufacturer's instructions, may cause interference to radio and television reception. It has been type tested and found to comply with the limits for Class B device in accordance with the specifications in Subpart "B" of Part 15 of FCC Rules, which are designed to provide reasonable protection against such interference in any residential installation. [. . . ] When you have access to the system, a Fire, Auxiliary or Panic alarm can be initiated with the press of a single key. Note that these functions will not work unless they are enabled by your installer or if you have accessed your security system from a remote phone. Ensure that your installer informs you whether or not these functions are enabled on your security system. [1] Fire To sound a Fire Alarm, access the system with a local phone. When you hear the status of the system, press the [1] Key and hold it for 2 seconds. You will hear a tone and then the message "Fire alarm". The bell will sound and the alarm will be transmitted to the monitoring station. [2] Auxiliary To sound an Auxiliary Alarm, access the system with a local phone. When you hear the status of the system, press the [2] Key and hold it for 2 seconds. You will hear a tone and then the message "Auxiliary alarm". [3] Panic To sound a Panic Alarm, access the system with a local phone. When you hear the status of the system, press the [3] Key and hold it for 2 seconds. If your system has been programmed for a silent panic alarm, you will hear nothing further. If the panic alarm is not programmed to be silent, then you will hear a tone and then the message "Panic alarm" and the bell/siren will sound. 10 QUICK-ARM FEATURE When the Quick-Arm feature is enabled, the system may be armed by entering [, ][0] instead of an Access Code. Note that the [, ][0] command will only arm the system; it will not disarm the system. The Quick-Arm feature can be used to allow a person, such as a baby-sitter, to arm the system without having to be provided with an Access Code. ENABLING THE QUICK-ARM FEATURE With the system disarmed, access the system as described in the `Accessing Your Security System' section of this manual. While you are listening to the status of the system, press the [, ] Key. You will hear the options available from the Options Menu ("Select Options. . . "). While the Options Menu is being announced, press the [6] Key to enter the User Functions Menu. You will then hear "Enter Master Access Code". You will hear the functions available from the User Functions Menu ("User Function Menu. . . "). [. . . ] · Write the plan down and rehearse frequently so that should an emergency arise, everyone will know what they are to do. Revise the plan as conditions change, e. g. more or fewer family members or changes to the house. · Make sure your fire warning system is operational by conducting weekly tests as noted elsewhere in this manual. [. . . ]