User manual DSC PC 5010

[. . . ] About Your Security System Your DSC Power832 Security System has been designed to provide you with the greatest possible flexibility and convenience. Read this manual carefully and have your installer instruct you on your system's operation and on which features have been implemented in your system. All users of this system should be equally instructed in its use. Fill out the "System Information" page with all of you zone information and access codes and store this manual in a safe place for future reference. Fire Detection This equipment is capable of monitoring fire detection devices such as smoke detectors and providing a warning if a fire condition is detected. [. . . ] Troubles can only be viewed when the system is in the disarmed state. If a trouble occurs while the system is armed, enter your access code to disarm the system, then follow the procedure outlined below to determine the specific trouble. NOTE: A TROUBLE condition reduces the security your system is designed to provide. Call your installing company for service. To view troubles from an LED Keypad: A trouble will be indicated by the Trouble light which will remain ON until the trouble condition is cleared. If you cannot determine or remedy the cause of the trouble condition, contact your installer for assistance. To view the type of trouble condition, press [D][2]. One or more zone lights will turn ON, indicating the various trouble conditions: ZONE LIGHT TYPE OF TROUBLE 1 . . . . . . . . . . . . . . . . . Press [1] and one or more of the zone lights corresponding to the following system troubles will turn ON: 1. When this trouble occurs, the Trouble light will turn ON but the keypad buzzer will not sound. The panel has failed to communicate with the central station. Press [5] and the zone light(s) corresponding to the faulted zones will turn ON. Press [6] and the zone light(s) corresponding to the tampered zones will turn ON. Press [7] and the numbers corresponding to the zones with battery trouble will turn ON. To set the system time, following the instructions in "Setting System Date and Time" on page 13. To view troubles from an LCD Keypad: From the Ready state, use the arrow (< >) keys to scroll to the following message. System Trouble Press [D] [2] to view the trouble. (*2) to View< > View Trouble < > Use the arrow (< >) keys to view which troubles are present on the system. Once "Trouble Message" you have scrolled through the list of troubles, press the [#] key to exit the Trouble Viewing mode and return to the Ready state. 12 Setting the System Date and Time To set the system time, enter [D] [6] followed by the Master Code. The keypad will now accept 10 consecutive digits: · Enter the Time in Hours and Minutes using the 24 Hour format (00:00 to 23:59). · Enter the Date in Months, Days and Years (MM DD YY). NOTE: If you have an LCD keypad, your installer may have programmed your system to display the time and date while the keypad is idle. If this is the case, you may have to press the [#] key to clear the date and time before entering an access code to arm the system, or before performing any other keypad function. Testing Your System Alarm Test The Alarm Test provides a two second test of the keypad sounder and bell or siren. Begin with the panel in the Ready state. From an LED keypad, Enter [D][6][Master Code][4] then press [#] to return to the Ready state. [. . . ] However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: · Re-orient the receiving antenna. · Increase the separation between the equipment and receiver. · Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. [. . . ]