User manual DSC PC1575

[. . . ] Instruction Manual PC1575 AVIS: L'étiquette de l'Industrie Canada identifie le matériel homologué. Cette étiquette certifie que le matériel est conforme à certaines normes de protection, d'exploitation et de sécurité des réseaux de télécommunications. Industrie Canada n'assure toutefois pas que le matériel fonctionnera à la satisfaction de l'utilisateur. Avant d'installer ce matériel, l'utilisateur doit s'assurer qu'il est permis de le raccorder aux installations de l'entreprise locale de télécommunication. [. . . ] Press to advance display to the next function or m essage. Press to see previous function or m essage. TEST SYSTEM WEEKL Y Refer to Instruction Manual for testing instructions. 2 5 3 6 NO IN USE T NOT IN USE NO IN USE T TEST SYSTEM WEEKL Y Refer to Instruction Manual for testing instructions. NO IN USE T NOT IN USE NO IN USE T The Liquid Crystal Display (LCD) displays prompts and system information on two 16 character lines. If "< >" appears, more information can be accessed by using the arrow (< >) keys. Press [<] to see the previous function or item of information. Press [>] to advance the display to next function or item of information. Press the keys on the number pad as prompted by the LCD display to view alarms or troubles, to arm and disarm the system and to bypass zones. To exit a function and return to the Ready state, press [#]. To select a function press [D]. Important Note: Test system weekly and have any system trouble conditions corrected by your alarm installer. Zone Bypassing The zone bypassing function is used when access is needed to part of the protected area while the system is armed. Zones which are temporarily out of service due to damaged wiring or contacts may be bypassed to allow system arming until repairs can be made. Zones cannot be bypassed once the system is armed. Bypassed zones are automatically cancelled each time the system is disarmed and must be reapplied before the next arming. NOTE: For security reasons, your installer may program the system to prevent you from bypassing certain zones. Bypassing zones reduces your security protection. If you are bypassing a zone due to damaged wiring or contacts, please call a service technician immediately so that the problem can be resolved and your system returned to proper working order. Do not unintentionally bypass zones when you arm your system. To bypass zones from an LED keypad: Start with the system in the Ready state. Enter [D][1][Zone number(s) to be bypassed]. Enter the zone number(s) as a single digit from 1 to 6. As each zone is bypassed, the corresponding zone light will turn ON. If a zone is bypassed by mistake, press that zone number again and the zone light will turn OFF, indicating that the zone is not bypassed. To recall the last group of bypassed zones: Enter [D][1][9]. The zone lights corresponding to the last group of bypassed zones will turn ON. [. . . ] If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: · Re-orient the receiving antenna. · Increase the separation between the equipment and receiver. · Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. · Consult the dealer or an experienced radio/television technician for help. [. . . ]