User manual DSC PC2000

[. . . ] INTRODUCTION Congratulations on your purchase of a DSC PC2000 Burglar Alarm Control system. The PC2000 has been designed to give you the greatest possible flexibility and convenience in the use of your security system. This booklet is intended to serve as a handy reference and should be kept in a secure place. Your security system consists of a number of different components. [. . . ] I- DEFECTIVE STANDBY BATTERY 2- AC POWER FAILURE 3- BLOWN FUSE IN CONTROL PANEL 4- TELEPHONE LINE PROBLEM 5- UNSUCCESSFUL COMMUNICATION ATTEMPT WITH MONITORING STATION 6- not used 7- BELL/SIREN CIRCUIT DEFECTIVE 8- MEMORY LOSS (USE MASTER CODE TO REPROGRAM) Press the [#] to return to `READY'. ALARM MEMORY DISPLAY If the `MEMORY' light is on an alarm has occured. The memory will be cleared when the panel is re-armed. Press the [*I then [3] keys to display which zone caused the alarm. Press [#] to return to `READY'. . ARMED light will come on indicating system armed. Ensure READY light on, enter 4 digit code. MEMORY light on means an alarm has occurred To display zone that caused alarm, press @I then &I. Zone light will come on indicating which zone caused alarm. ZONE light(s) when on in the normal operating mode indicate an open zone. Refer to zone chart on keypad door for detailed zone information. Ready tliht must be on. Enter code ZONE BY-PAStNO: Press @ then CT] keys. AURM MEMORY: i'ms. s &I then @j. ' KS SYWEht FltEQtJE~y SHUNT light will come 1 on when you by-pass a zone. To by-pass a zone, press 63 then ci3 and then the zone(s) you wish to by-pass. r c I Program TROUBLE light on means there is a fault on the system. Press &I then q to display trouble type: 1. Power up PROGRAM light is on when you pro ram user codes. Press * then @ then PI enter Master Code, program light will come on. Select which code you wish to program 1 thru 8, then enter 4 digit code. Program light must be "on" to add or change user codes. Key pad door has zone identification and basic user instructions. Protects keypad when keypad not in use. ALARM TEST Press I*] lhen [4] for a 4 second lest of the keypad lights, keypad sounder and sirens. A lest transmission to the monitoring station is not done with this command. PROGRAMMING ADDITIONAL SECURITY CODES Enter [*I&] and [master security code]. The `PROGRAM' light will flash and the `ZONE' lights will show which codes have already been programmed (up to 8 codes can be programmed from the keypad). Press any key from (1 to 81 to indicate which one of the 8 codes is being programmed. The `ZONE' light will flash to indicate which code is being programmed. [. . . ] Pressing [S] again will turn off the "ALERT". The sounder will give one long beep. AUTO-TEST TRANSMISSION The PC2000 can be programmed, at the time of installation, to send a test code to the monitoring station at regular intervals. The frequency and time of test transmissions is set by the monitoring station and should not be changed without their knowledge. DURESS CODE The duress code feature must be programmed into the PC2000 at the time of installation. When the duress code is used instead of a normal security code for disarming, the system disarms as normal but a special duress code is sent to the monitoring station. [. . . ]