User manual DSC PC4000

[. . . ] Jan 11, 1993 Software Version 1. 3 INSTRUCTION MANUAL PC4OOO SECURITY SYSTEM DOC NOTICE NOTICE: The Canadian Department of Communications label identifies certified equipment. This certification means that the equipment meets certain telecommunications network protective, operational and safety requirements. The Department does not guarantee the equipment will operate to the user's satisfaction. Before installing this equipment, users should ensure that it is permissible to be connected to the facilities of the local telecommunications company. [. . . ] The "Alarm Memory" message will only be displayed when an alarm occurred during the last armed period. Press [#] to return to "READY". USER FUNCTIONS COMMAND []+[6]+[ACCESS CODE] Enter [][6][Access Code] and then use the [<][>] keys to display the items of the function menu. [0] Quick Arm [1] Quick Exit [2] Auto Arm Control [3] Keypad Setup [4] Bell/Comm Test [5] Door Chime [6] Spec. Messages [7] User Call Up [8] View Partitions Item [0], [1], [5] and [6] turn on and off various functions. To enable or disable these functions, press the [] key to toggle "Y "or "N" on the keypad. Y - The function is enabled N - The function is disabled QUICK ARM []+[6]+[ACCESS CODE]+[0] The "Quick Arm" feature is enabled by toggling to "Y" on the keypad. When enabled the panel can be armed by entering [][0]. One time use access codes should not be used with the quick arm feature. The one time use code is only erased when used to arm. QUICK EXIT []+[6]+[ACCESS CODE]+[1] The "Quick Exit" function is enabled by toggling to "Y" on the keypad. When enabled the user can exit through any delay zone without altering the status of the system, by entering [][0] on the keypad. AUTO ARM CONTROL []+[6]+[ACCESS CODE]+[2] This function must be enabled by the installer, or an error tone will sound when this section is entered. The PC4000 can be programmed to arm a partition at the same time each day, by enabling the Auto Arm function and programming the Auto Arm time. At the selected Auto Arm time, the system will give a pre-alert. The keypad begins to sound and the Bell/Siren will pulse once every 10 seconds to alert anyone on the premises that the system is about to arm. The Bell/Siren pulse can be programmed by the installer to be silent. The keypad will sound for one minute before Auto Arming unless the Auto Arm is aborted. To abort the Auto Arm and silence the keypad press any key during the pre-alert. The Auto Arm will be attempted at the same time the following day. The PC4000 can be programmed to require a code to be entered for a user to abort the Auto Arm by the installer. Upon selecting the Auto Arm Control function, the Auto Arm Control menu will appear on the LCD keypad. [0] Auto Arm [1] Auto Arm Time 6 Auto Arm toggles "Y" or "N" to enable or disable the Auto Arm function. [. . . ] It has been type tested and found to comply with the limits for Class B device in accordance with the specifications in Subpart "B" of Part 15 of FCC Rules, which are designed to provide reasonable protection against such interference in any residential installation. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause interference to television or radio reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: s Re-orient the receiving antenna s Relocate the alarm control with respect to the receiver s Move the alarm control away from the receiver s Connect the alarm control into a different outlet so that alarm control and receiver are on different circuits. If necessary, the user should consult the dealer or an experienced radio/television technician for additional suggestions. [. . . ]