User manual DSC PC4020 V3.3 REV1

[. . . ] ® PC4020 v3. 3 · Instruction Manual WARNING: This manual contains information on limitations regarding product use and function and information on the limitations as to liability of the manufacturer. The entire manual should be carefully read. FCC COMPLIANCE STATEMENT CAUTION: Changes or modifications not expressly approved by Digital Security Controls Ltd. could void your authority to use this equipment. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. [. . . ] This is the time at which the partition will automatically arm itself every day. Enter the time using the 24 hour format (HHMM). The keypad will return to the Auto-Arm Control menu. Scheduled Auto-arming The panel can also be programmed to automatically arm according to a schedule. Schedules can only be programmed by your installer. If you want more information regarding scheduling and your security system, please consult your installer. NOTE: Auto-arm must be enabled for Scheduled Auto-arming to work. To enable auto-arming according to a schedule: 1. Use the arrow keys (<>) to scroll to the Auto-Arm Control menu. Use the arrow keys (<>) to scroll to the "Auto Arm" display. To change the Auto Arm setting, press [0] or [*]. Use the arrow keys (<>) to scroll to "Schedule Arm. " To change the Schedule Arm setting, press [1] or [*]. This option, when enabled, will program the partition to automatically arm according to a schedule programmed by your installer. Use the arrow keys (<>) to scroll to "Sched. Disarm. " To change the "Sched. When this option is enabled, the partition will follow the auto disarming schedule programmed by your installer. When Auto Arming Occurs At the selected auto arm time, the keypad will beep once every 10 seconds to alert anyone on the premises that the system is about to arm. The bell or siren may also sound every 10 seconds, if programmed by your installer. To prevent the system from auto arming, press any key on the partition keypad during this pre-alert period. If desired, your installer can program the system so that a valid access code will be required to prevent the system from auto arming. Swiping an access card on one of the partition's readers--if installed--will also prevent auto arming. 3. 4 Setting the Time and Date Keypad Command: [Master Code][9] To set the time and date on the system, perform the following: 1. Use the keypad arrow keys (< >) to scroll to the display "Set System Time. " Press [*]. [. . . ] L'abonné ne doit pas oublier qu'il est possible que la conformité aux conditions énoncées ci-dessus n'empêchent pas la dégradation du service dans certaines situations. Les réparations de matériel homologué doivent être effectuées par un centre d'entretien canadien autorisé désigné par le fournisseur. La compagnie de télécommunications peut demander à l'utilisateur de débrancher un appareil à la suite de réparations ou de modifications effectuées par l'utilisateur ou à cause de mauvais fonctionnement. Pour sa propre protection, l'utilisateur doit s'assurer que tous les fils de mise à la terre de la source d'énergie électrique, les lignes téléphoniques et les canalisations d'eau métalliques, s'il y en a, sont raccordés ensemble. [. . . ]