User manual DSC PC5502Z2

[. . . ] WARNING: This manual contains information on limitations regarding product use and function and information on the limitations as to liability of the manufacturer. The entire manual should be carefully read. PC 5502Z2 Instruction Manual Quick Reference - System Functions The following chart lists the basic functions of your system and the keys to press for each function. Refer to the listed page number for more information. NOTE: Some functions may not be available on your system. [. . . ] If the door is opened again, or if the door is not closed after two minutes, or if another zone is opened, the panel will begin the entry delay. Your installer will inform you if the Quick Exit feature has been enabled on your system. Turning off your system (Disarming) 1. Enter the premises through the designated entry/exit door. The keypad beeps to indicate that you must disarm the system. Go to the keypad and enter your [access code]. You must enter a valid access code before the entry time expires. If a valid access code is not entered during this time, the system will sound an alarm. As soon as the correct code is entered, the Armed light goes out and the keypad stops beeping. If you entered the access code incorrectly, the keypad sounder buzzes steadily for two seconds. 3 NOTE: Entering by any other door will immediately cause an alarm. 2. 3. If an alarm occurred during the last armed period, the System light will flash, and the lights for the zones in alarm will flash. What to do if your system has an alarm WARNING: If you return to the premises and the bell or keypad buzzer is sounding an alarm do not enter. Contact the local authorities from a nearby safe location. A two-tone keypad buzzer sound or a steady bell indicates an intrusion alarm. If the bell is ringing, you cannot silence it from the PC5502Z2 keypad. Contact your alarm system administrator for assistance. If the alarm was unintentional, call your central station or local authorities immediately to avoid an unnecessary response. Check the alarm memory display to see which zone caused the alarm. Once the source of the alarm has been corrected, the system will return to the Ready state. Viewing Alarms in Memory WARNING: If the alarm is not sounding, but there is an alarm in memory, it is possible that an intruder may still be on the premises. Go to a nearby safe location and call the local police to investigate. If an alarm occurred while the system was armed, the System light and the zone light corresponding to the zone that caused the alarm will flash for 30 seconds after the system has been disarmed. The alarm memory is cleared each time the system is armed. Any alarms showing on the system have occurred only during the last armed period. [. . . ] If warning devices are located on a different level of the residence or premise, then it is less likely that the occupants will be alerted or awakened. Audible warning devices may be interfered with by other noise sources such as stereos, radios, televisions, air conditioners or other appliances, or passing traffic. Audible warning devices, however loud, may not be heard by a hearing-impaired person. s Telephone Lines If telephone lines are used to transmit alarms, they may be out of service or busy for certain periods of time. [. . . ]