User manual DSC PC580 V2.3

[. . . ] ·WARNING· This manual contains information on limitations regarding product use and function and information on the limitations as to liability of the manufacturer. The entire manual should be carefully read. Instruction Manual Software Version 2. 3 WARNING Please Read Carefully Note to Installers This warning contains vital information. As the only individual in contact with system users, it is your responsibility to bring each item in this warning to the attention of the users of this system. System Failures This system has been carefully designed to be as effective as possible. There are circumstances, however, involving fire, burglary, or other types of emergencies where it may not provide protection. [. . . ] Once the new code is entered, the keypad will beep 3 times and the display will read. . . (*) to Edit <> Press [#] to exit the code programming function. User Code 40P Be sure to record your new Master Code on the "System Information" page in this booklet. NOTE: We recommend that the factory default Master Code [1234] not be used. Additional Access Codes To erase, add or change a user code, press [D] to enter the functions list. Use the arrow (< >) keys to scroll to the following message. . . Press (*) for <> Press [D]. Access Codes Enter Master Access Code Enter the Master Code. Display will read. . . [*] to Edit <> Use the scroll keys (< >) to find the access code ­ indicated by "02P" to "32P" ­ User Code 01P you wish to add, change or delete. Press the [D] key to select the code you wish to alter. To add or change a code, enter the new code. Access codes must be four digits Enter New Code 1234 <> unless otherwise indicated by your installer. Once the 4 digit code or [D] has been entered, the keypad sounder will beep 3 times and the display will read. . . [*] to Edit <> The "P" means the code has been programmed. If there is no "P" then that code is User Code 01P deleted. Press [#] to exit the code programming function. Remember to record your new code(s) on the "System Information" page in this booklet. 10 Zone Bypassing The zone bypassing function is used when access is needed to part of the protected area while the system is armed. Zones which are temporarily out of service due to damaged wiring or contacts may be bypassed to allow system arming until repairs can be made. Zones cannot be bypassed once the system is armed. Bypassed zones are automatically cancelled each time the system is disarmed and must be reapplied before the next arming. NOTE: For security reasons, your installer may program the system to prevent you from bypassing certain zones. Bypassing zones reduces your security protection. If you are bypassing a zone due to damaged wiring or contacts, please call a service technician immediately so that the problem can be resolved and your system returned to proper working order. Make sure that no zones are unintentionally bypassed when arming your system. To bypass zones from an LED keypad: Start with the system in the Ready state. Enter [D][1][Zone number(s) to be bypassed]. [. . . ] · Increase the separation between the equipment and receiver. · Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. · Consult the dealer or an experienced radio/television technician for help. The user may find the following booklet prepared by the FCC useful: "How to Identify and Resolve Radio/Television Interference Problems". [. . . ]