User manual DUAL CS-415-2

[. . . ] CS 415-2 HiFi automatic-turntable Operating Instructions WARNING: To Prevent fire or shock hazard, do not expose this product to rain or moisture 1 2 3 4 5 6 7 9 8 Fig. [. . . ] – Connect earth wire 9 to the earth connector of you amplifier. Automatic start, speed selection – The record diameter for the automatic start is also pre-selected when the record speed 33. 33 or 45 rpm 4 is selected. – Remove the stylus guard by pulling it forwards and disengage the tonearm set switch 6 to Start – The tonearm is lowered automatically onto the record. Manual start, cue control – Select the required platter speed, 33. 33 or 45 rpm, by means of the switch 4, swivel the stylus protection cap upwards, set the cueing lever 3 to position – Now position the tonearm over the lead-in groove of the record. The tonearm is now lowered slowly onto the record using the cueing lever 3. The tonearm is lowered slowly, thus preventing damage to your records. – The tonearm can be raised at any position, also for brief interruptions when playing, by means of the cue control lever (cueing lever in position ). The platter continues to rotate in this case. Stop – At the end of record, the tonearm is automatically repositioned back on the tonearm post and unit is switched off. – You can also switch off the turntable by setting the cueing lever 3 to position and repositioning the tonearm on the tonearm post. Stylus DN 251 S The stylus is subject to natural wear and tear during normal playing. Therefore, we recommend you occasionally check the stylus and, in the case of the diamond styli, this should be carried out after approximately 300 hours playing hours. [. . . ] 160 pF 440 x 110 x 360 mm Dimensions (W x H x D) NOTES For support visit www. dualturntables. com. au [. . . ]