User manual DUAL MXD40

[. . . ] Insulate wire if not used. AMP BLACK Ground 5 AMP AGC Fuse Connect to chassis ground. YELLOW Memory Connect to battery circuit or constant 12 volt source. 0. 5 AMP AGC Fuse FUSES RED Accessory Connect to existing ignition circuit or switched 12 volt source. When replacing fuses, make sure new fuse is the correct type and amperage. Using an incorrect fuse could damage radio. The MXD40 uses one . 5 amp AGC fuse (Ignition) and one 5 amp AGC fuse (Battery) located in-line. Right Front Gray/Black (-) Gray (+) Right Rear Violet/Black (-) Violet (+) Left Front White/Black (-) White (+) Left Rear Green/Black (-) Green (+) 3 MXD40 OPERATION Control Locations 1 2 3 4 5 6 18 17 16 15 14 13 12 11 10 9 8 7 1 2 3 4 5 6 7 8 9 Release Volume Tune/Track Up Band Bass Boost Eject Display Play/Pause Auto Store/Preset Scan 10 11 12 13 14 15 16 17 18 Preset 6 Preset 5 Preset 4/CD Random Preset 3/CD Repeat Preset 2/CD Intro Preset 1/CD Top Audio Power Tune/Track Down MARINE The MXD40 Marine Receiver features UV resistant faceplate construction and clear-coated circuit boards for long lasting protection against the elements in the marine environment. [. . . ] When stored, the preset number will appear in the display. The station can be recalled anytime by pressing the corresponding preset button. Automatically Store Stations Press AS/PS for more than 2 seconds to automatically store the six strongest stations in the current band. Preset Scan Press AS/PS for less than 2 seconds to scan presets 1-6 on the current band, pausing for 5 seconds at each. Press AS/PS again to cancel. 7 MXD40 OPERATION CD Player Operation Insert CD With the label facing up, insert a standard 5" CD into the CD slot. The CD will automatically begin playback. Press the EJECT button to stop and eject the CD. Press TRACK to skip to the beginning of the next track. Press TRACK to return to the beginning of the current track. Pressing TRACK again skips to the beginning of the previous track. Press and hold TRACK or reverse a track. Press Press or TRACK to fast forward Eject CD Track Select Fast Forward and Reverse Pause l// II to temporarily stop CD playback. l II again to resume playback. Intro Press INT to play the first 10 seconds of each track. Press RPT to continuously repeat selected track. Press RDM to play all tracks in random order. Press TOP to begin playback from track 1. Some CD-Rs may be incompatible with this unit, depending on media type and recording method. This model does not support CD-RWs. Repeat Random Top CD-R Compatibility 8 MXD40 WARRANTY Limited One-Year Warranty This warranty gives you specific legal rights. You may also have other rights which vary from state to state. warrants this product to the original purchaser to be free from defects in material and workmanship, under normal conditions, for a period of one year from the date of the original purchase. Namsung America agrees, at our option, during the warranty period, to repair any defect in material or workmanship or to furnish an equal new or renewed product in exchange without charges, subject to verification of the defect or malfunction and proof of the date of purchase. During the One-Year Warranty Period: For One Year from the date of purchase, your product will be replaced with a new, renewed or comparable product (whichever is deemed necessary) if it becomes defective or inoperative. Replacement products are warranted for the balance of the original warranty period. This warranty is extended to the original retail purchaser for products purchased and used in the U. S. A. , in the 48 contiguous states ONLY. [. . . ] Ensure an area large enough for the speaker to mount evenly. Be sure the mounting location is deep enough for the speaker to fit. · Using an appropriate tool, cut a 5. 13" diameter mounting hole. Route speaker wires and connect to speakers, observing speaker polarity. [. . . ]