User manual DUAL SBX653

[. . . ] Parts of the following instructions may not apply to your installation. The installation instructions included here are basic. If you feel unsure about installing the speaker system, Dual recommends that you seek installation by a qualified auto sound technician. Before installation, please follow these rules: 1. Be sure to carefully read and understand the instructions before attempting to install the product. For safety, disconnect the negative lead from the battery prior to beginning the installation. [. . . ] The first is labeled audio input terminals and the second is labeled illuminite lighting inputs. The inputs are clearly marked with a label positioned directly above the terminal housing. The polarity (+ and -) indicators for each set of inputs also appear on these labels. Do not connect Amplifier or any audio source to illuminite lighting inputs. Inputs are designed for switched 12 volt power source only. More then 3V rms connected to illumination inputs can cause permanent damage to the lighting elements. 1a, (illustrates wiring diagram) be sure to maintain polarity. Be sure to connect to a constant switched 12 volt source. Correct connection would be the positive (+) 12 volt wire to the Positive (+) illuminite Lighting input terminal and connect the Negative (-) illuminite lighting input terminal to a good chassis ground. Fig 1a Lighting Hook-Up From Rear 12 volt source Audio Input Terminals Illuminite Lighting Input Terminals Head unit Ground Notice: The IlluminiteTM series LED illumination elements are not removable. There are no serviceable parts inside or attached to the speaker assembly. The IlluminiteTM series products are sensitive electronic devices. Removal or tampering with any part or portion of the speaker and/or its assemblies will damage the product and void the limited warranty. 4 XNP - SBX SERIES INSTALLATION Mounting 1. Determine where the speakers will be mounted. Ensure an area large enough for the speaker to mount evenly. Be sure that the mounting location is deep enough for the speaker to fit. Refer to the specification chart to determine the proper diameter hole to cut for your speaker model. If supplied, use the plastic mounting ring as a template to mark the locations for the mounting screws. Be sure to observe proper polarity when connecting the wires. [. . . ] Before you call for service, check your operating instruction booklet. A slight adjustment of any custom controls discussed in your instruction booklet may save you a service call. If you require service during the warranty period, you must carefully pack the product (preferably in the original package) and ship it by prepaid transportation with proof of the purchase date from the retailer to the Return Center address listed below. Please describe your problem in writing and include your name, a return UPS shipping address (P. O. [. . . ]