User manual DUCATI CTR18

[. . . ] Any inaccuracies or errors found in this manual will be corrected in the next edition. Electronic board controlling 1 230 Vac single-phase asynchronous motor for the automation of a sliding gate or an overhead door with or without limit switch. Caution : Before operating the electronic unit make sure the following operations have been carried out Note 1 ­ Note 2 ­ Note 3 ­ Note 4 ­ Note 5 ­ Note 6 ­ Note 7 ­ Read carefully the whole technical documentation supplied. the electronic unit must be installed by qualified personnel only. [. . . ] The led goes off when the photo-cell is covered by persons or vehicles . lD4 ­ Stop led (red) It signals the gate's block state. The led goes off when the stop control is operated (emergency). lD3 ­ Start led (green) It is lit when the start control is operated. LD1 ­ Power supply led (green) It is lit when the electronic card power supply is present. RV3 ­ Work time It defines the motor's work time during the opening or closure phases. SW1 - Dip switch 1 It chooses whether the unit will operate in step-by-step mode or in automatic mode. ON =Automatic OFF=Step by step SW1 - Dip switch 2 It chooses whether the unit will operate in the mode determined by dip-switch 1 or in condominium mode. Opened Dip Fix = electrochain mode Closed Dip Fix = courtesy light mode F1 ­ Mains power fuse (5A) It disconnects the electronic unit from the power supply mains in case of short-circuit or electric current consumption anomalies. F2 ­ Low voltage fuse (2A) It protects the electronic unit in case of short circuits or overcurrents on photo-cells, electric lock or any other accessory devices connected to the 24 Vac power supply. Power regulator It protects the electronic unit in case of short circuits or overcurrents on photo-cells, electric lock or any other accessory devices connected to the 24 Vac power supply. Caution: In case failure or anomaly of the power regulator card the motor may operate at its maximum power value. This is why n° 7 note in the previous chapter "limits to use" must absolutely be put into practice. Starting of maximum start up power When the motor starts the unit supplies the maximum power value for approx. Subsequently the unit's power regulator card, if present, operates. Radioreceiver The electronic unit is pre-set for the optional connection of an accessory radio receiver card allowing remote control of the gate by means of the radio transmitter. The channel 1 of the radio receiver card ends with a non-polarized electric contact (relay) directly connected to the start input. The channel 2 of the radio receiver card ends with a non-polarized electric contact (relay) directly connected to the 2nd radio channel output. Quick flashing light : it signals the opening phase. Slow flashing light : it signals the closing phase. Fixed light : it signals that the gate is blocked in pause before the closure phase in "automatic" mode. Work time The motor's work time is controlled by one digital timer. [. . . ] The operating cycle is complete only when the closing motion has ended. If a start command is supplied while the gate opens, the command will have no effect. If a start command is supplied while the gate closes, the gate will stop and reverse its motion after approx. If a start command is supplied during the pause period, the period will be reset and the automatic closure will start later. [. . . ]