User manual DUCATI CTR29

[. . . ] When the motor is connected to the mains power the torque it apply to the roller shutter must respect the applicable rules and, in any case, it must be such that in case of collision no damage will be caused to persons, animals or objects. Note 8 - The unit must be applied for the intended use only (see point A). All other use is to be considered improper and dangerous ENGLISH Note 9 Before acceding to the electronic unit's box for any intervention check that the mains power has been cut off. Do not access the unit with wet/damp hand or feet. [. . . ] Push-button is usually connected to this input. 2) DEFINITIONS OF OUTPUTS Motor 1 Outputs for the opening/closure control of the motor which drives the roller shutter . 3) DEFINITIONS OF POWER SUPPLY INPUTS 230 Vac mains power Input for the electronic board power supply. 4) DEFINITIONS OF INPUTS Aerial Input for the connection of a radio receiving aerial. 5) DEFINITIONS OF OPTICAL SIGNALS LD1 - Power supply led (red) It is lit when the electronic card power supply is present. 6) DEFINITIONS OF TIMERS Work time It defines the motor's work time during the opening or closure phases. 7) DEFINITIONS OF JUMPERS (SELECTION OF PROGRAMS) JP1 jumper It determines whether the unit will operate in step-by-step, manual or cyclical mode. ENGLISH 8) DEFINITION OF PROTECTION FUSE F1 - Mains power fuse (5A) It disconnects the electronic unit from the power supply mains in case of short-circuit or electric current consumption anomalies. 9) TECHNICAL FEATURES Radioreceiver The electronic unit contains a two-channel radio receiver allowing remote control of the roller shutter by means of the radio transmitter. the radio receiver channel 1 acts as Opening start , whereas channel 2 acts as Closing start. The radio receiver operates with a self-learning logic and can store up to 120 different codes from the radio-commands. Each code may be addressed on the desired channel (opening start or closing start). The memory contents is preserved in absence of power supply. The memory contents may be erased (total cancellation). Work time The motor's work time is controlled by one digital timer. For the automation system to work properly the operating time value to be set must be slightly (min. ) above the roller shutter's actual work time. If any command interrupts the roller shutter's travel before its end, the Timer stops and the elapsed time is stored in memory. Therefore the unit can determine, with a fair approximation, the partial working time necessary to the roller shutter to end its travel. In case of limit switch lack, thanks to this feature it is possible to avoid that the motor works for a long time after the end of the roller shutter's travel, thus reducing overheating to the minimum. Warning : In case of absence of power supply the stored position will be lost. These are the main operation modes : "Step-by-step" mode (JP1 jumper = not inserted) When the roller shutter is closed, the opening start command determines an opening cycle. [. . . ] Company name and registered office : Leb electronics s. 01 Reference rules applied : EN 50081-1, EN 50082-1, EN 55014 Basic rules applied : EN 61000-3-2, EN 61000-3-3, EN 61000-4-4, EN 61000-4-2, ENV 50140 Test laboratory : Intek s. Radio-command codes self-learning : Press the P1 push-button once to insert a "Opening Start" code; press the P1 push-button twice to insert a "Closing Start" code. When the led is lit with a fixed light transmit the code to be learn by means of the radio-command. [. . . ]