User manual DUCATI CTR45

[. . . ] Any inaccuracies or errors found in this manual will be corrected in the next edition. Electronic board controlling 1 or 2 230Vac single-phase asynchronous motors for the automation of a single or two-wing gate. Caution : Before operating the electronic unit make sure the following operations have been carried out. Note 1 ­ Read carefully the whole technical documentation supplied. [. . . ] kickback This procedure can be enabled or excluded. It is usually employed to help the electric lock release during bad weather conditions (wind, ice, etc. The "kickback" procedure consists of a logic sequence operating the electric lock during a short closure phase (approx 1 sec. The electric lock is released only after the wing has started its opening motion. M1 delay at opening The unit causes a fixed delay of approx. 2 seconds between the first wing's (M2) and the second wing's (M1) start during the gate's opening phase. This delay is imposed irrespective of the position from which the gate starts to open. This delay may be cancelled (see "Card programming"). The unit can operate in three modes : - Step by step - Automatic - Condominium The Condominium mode is the priority operation mode. If more than one modes are selected the priority mode will be enabled. Notice: The operation logic setting (dip switch), the work time programming and the pause time programming must be carried out only if the cycle is concluded or before it starts (with closed gate). "Step-by-step" mode After the power is supplied to the electronic card the first start command determines an opening cycle. At the end of the two work times, the gate stops. The operating cycle is completed (blinker off) and the system waits for a new start command to determine the closing cycle. If a start command is supplied when the end of travel has not been reached yet the gate stops. A new start command will cause the reversal of the motion. "Automatic" mode After the power is supplied to the electronic card the first start command determines an opening cycle. At the end of the two work times, the gate stops. At the end of the pause period the gate closes automatically. The operating cycle is complete only when the closing motion has ended. If a start command is supplied before the end of travel is reached the gate stops. A new start command will cause the gate to reverse its motion. [. . . ] When the led is lit with a fixed light transmit the code to be learn by means of the remote control. When the operation has ended, restore the Jumpers as in origin. Press the key P1 until the led LD1 goes off (about 10 sec. When the operation has ended, restore the Jumpers as in origin. [. . . ]