User manual DUCATI HYPERMOTARD 1100 S

[. . . ] Owner's manual E 1100S / 1100 1 E 2 Hearty welcome among Ducati fans!Please accept our best compliments for choosing a Ducati motorcycle. We think you will ride your Ducati motorcycle for long journeys as well as short daily trips. We are steadily doing our best to improve our "Technical Assistance" service. [. . . ] 48 60 Pre-ride checks Warning Failure to carry out these checks before riding, may lead to motorcycle damage and injury to rider and passenger. Before riding, perform a thorough check-up on your bike as follows: Fuel level in the tank Check fuel level in the tank. Engine oil level Check oil level in the sump through the sight glass. Brake and clutch fluid Check fluid level in the relevant reservoirs (page 70). Tyre condition Check tyre pressure and condition (page 84). Controls Work the brake, clutch, throttle and gear change controls (levers, pedals and twistgrips) and check for proper operation. Lights and indicators Make sure lights, indicators and horn work properly. Replace any burnt-out bulbs (page 78). Key-operated locks Ensure that fuel filler plug (page 49) and passenger seat (page 50) are firmly secured. Stand Make sure side stand operates smoothly and is in the correct position (page 52). Warning In case of malfunction, do not ride the motorcycle and contact a DUCATI Dealer or Authorised Workshop. E 61 Starting the engine Warning Before starting the engine, become familiar with the controls you will need to use when riding (see page 10). 4) on the instrument panel are on. PUSH ON FF ON O CK LO P IG NIT IO N E Important The oil pressure light should go out a few seconds after the engine has started (page 11). Note The engine can be started with the side stand down and the gearbox in neutral, or with a gear engaged and the clutch lever pulled (in this case the side stand must be up). fig. 49 62 2) Check that the stop switch (1, fig. 50) is positioned to (RUN), then press the starter button (2). This model is equipped with a servoignition system. To achieve assisted engine starting, press the button (2) and release it immediately. Pressing the button (2) operates automatic engine starting for a maximum period of time that varies depending on engine temperature. When the engine has started, the system prevents the starter motor from turning over. If the engine fails to start, allow at least 2 seconds before pressing the starter button (2) again. Let the engine start without using the throttle control. 1 E 2 fig. 50 Note If the battery is flat, the system will automatically inhibit engine cranking (starter motor). Important Do not rev up the engine when it is cold. Allow some time for oil to reach all points that need lubricating. 63 Moving off 1) Disengage the clutch squeezing the control lever. 2) Push down on gear change lever sharply with the tip of your foot to engage the first gear. 3) Speed up engine, by turning the throttle twistgrip and slightly releasing the clutch lever at the same time; the motorcycle will start moving off. [. . . ] Inspections, replacement of parts and other services and adjustments required for routine maintenance. Any motorcycle on which odometer mileage has been changed so that actual mileage cannot be readily determined. The liability of Ducati under this Emission Control Systems Warranty is limited solely to the remedying of defects in material or workmanship by an authorized Ducati motorcycle dealer at its place of business during customary business hours. This warranty does not cover inconvenience or loss of use of the motorcycle or transportation of the motorcycle to or from the Ducati dealer. [. . . ]