User manual DURKOPP 0791 867708 FITTING INSTRUCTIONS

[. . . ] Before beginning the installation: Please check whether all the components of the kit have been correctly delivered. Component 1 2 1 1 2 x x x x x Thread tensioner plate Countersunk screw M4 x 12 Cable harness Holder M-Control Chip board screw 3. [. . . ] Fix the keypad 8 using the three screws 9. Fix the new thread tensioner plate 11 using the screws 10 and 12. Run the cable 5 from the thread tensioner plate behind the operating panel to the PCB 6. The cable that runs from the output "ST2" on the control unit to the input "X11" on the PCB must be dismantled and replaced by the cable harness that is part of the kit. Run the new cable harness 2 through the table top cutout to the machine head. Fix the cable harness onto the machine head by using the clip 3. Run the cable 1 to the control unit 5 trough the cable channel 2. Set the rotary switch 4 inside the box to position "2". connect the plug x1 to the bush 3 on the control box. Fix the the box 5 with the additional control by screwing it underneath the table plate. [. . . ] The following parameters have to be set on the control unit: F-13 =1 F-100= 2 F-115=250 F-116=140 F-134 =1 F-136=2 F-154=8 F-180=45 F-181=20 F-182=1 Thread trimmer on/off Number of soft start stitches (change from 1 to 2) Softstart speed (change from 400 to 250) Trimming speed (change from 150 to 140) Soft start on/off Short thread trimmer stitch Function thread clamp Reversing angle Switch-on delay of reverse motor rotation (change from 0 to 20) Reverse motor rotation on/off Note: The functions "thread clamp" and "neat seam beginning" are not yet active at the first sewing start after switching on the control unit. The functions are activated only after the first thread trimming. [. . . ]