User manual DURKOPP 804-1

[. . . ] Copyright © Dürkopp Adler AG - 2010 Foreword This instruction manual is intended to help the user to become familiar with the machine and take advantage of its application possibilities in accordance with the recommendations. The instruction manual contains important information on how to operate the machine securely, properly and economically. Observation of the instructions eliminates danger, reduces costs for repair and down-times, and increases the reliability and life of the machine. The instruction manual is intended to complement existing national accident prevention and environment protection regulations. [. . . ] There are a total of 20 independent memory locations available. Each memory location can be occupied by a sequence of up to 30 sewing programs in any imaginable order. -> Sequence A new sequence will be generated. 1 ­ ­ ­ Tip onto the desired sewing program. In the example NP1 Tip onto the button "Insert". The sewing program is adopted and will be displayed in the sequence field. Insert additional sewing programs. 25 ­ ­ ­ ­ Tip onto the button "Set name". The sequence will be memorized. 26 7. 6. 3 Opening a sewing program or a sequence Via this menu item, sewing programs or sequences can be opened from the DAC and then be sewn. After opening the main screen will be updated accordingly. ­ Click File -> Open The following screen will appear: 1 ­ Click "File filter". The file filter will be opened. According to the selection the following will be displayed: · · · All files Seam programs (. fnp804-1) Sequences (. seq804-1) 27 7. 6. 4 Copying a sewing program, a sequence or machine parameters Via this menu item it is possible to copy sewing programs, sequences or machine parameters onto the DAC control or onto a USB-Stick. And a file filter can also be selected here. After a further actuation of the pedal the seam will be started. Mode 3 The clamp will be opened in the feeding position. After actuating the pedal the right part of the two-piece clamp for an angular feed will be closed. After actuating the pedal one more time the left side will be closed. After a further actuation of the pedal the seam will be started. Mode 4 Quick start mode The clamp will be opened in the feeding position. After actuating the pedal the clamp will be closed. With the change-over clamp, the seam will be started automatically after feeding. This mode is only active if the quick start has been enabled with the machine parameters. In order to activate the quick start mode, the machine must be switched off and on again! 30 Mode 5 The clamp remains closed in the feeding position. After actuating the pedal one more time the seam will be started. [. . . ] ­ Switch on the repair mode. 1 ­ ­ Go to the point from where the sewing shall continue with the two buttons "Forwards" (forwards) or "Reverse" (backwards). Press the "Continue sewing" button. From this repair point the seam will be sewn to the seam end. 55 7. 13 Thread breakage After a thread breakage the thread can be threaded in again and the sewing of the seam contour can be continued from any point. ­ ­ ­ ­ Press the "Bobbin change" button. The work clamp will go to the bobbin change position. [. . . ]