User manual DYMO 2000

[. . . ] The last label created will be retained and displayed when next turned on. In addition, any stored settings will be retained. Note: If the batteries are removed for more than a few seconds, all text and stored settings will be lost. When power is restored, the display will show a flashing cursor (no text) and the settings will be medium height and all other settings off. [. . . ] This is a two line label in the display will be printed as: This is a two line label and the display will indicate 2 lines: 1 2 3 Labels can be created as follows: 6mm 9mm 9mm 12mm 1 line small text Up to 2 lines small text 19mm Up to 4 lines small text 1 line medium text 19mm Up to 2 lines small text Up to 2 lines medium text 12mm 1 line medium text 19mm 1 line large text SYMBOLS + JUST Press to select a symbol character see SYMBOLS AND SPECIAL CHARACTERS and the symbols table on page 2. TEXT SIZE SIZE The display shows the current selection of text print size: The line indicator in the display will confirm the number of lines in the label. BOXED/UNDERLINED PRINTING BOX/UL The display shows the current selection. Press BOX/UL once to put a line box around the label (confirmed by the A indicator in the display). Press a second time to underline all the text on the label (confirmed by the A indicator in the display). Press a third time to cancel and return to normal text. + BOX/UL ITALIC Press once to print the label in italic text (confirmed by the A indicator in the display). Press again to cancel and return to normal text. LENGTH ITALICS small height medium height large height small height, extended medium height, extended large height, extended Large height is available on 19mm labels only. Medium height is available on all except 6mm labels. Small height is available on all labels. Press SIZE repeatedly to select the size symbol required. JUSTIFY JUST Labels are normally printed with the text left-justified. On multi-line labels, press JUST to select left-justified, right-justified or centred text, as shown in the display. VERTICAL TEXT VERT Rotates the text through 90 so that the label is printed , as confirmed by the VERT indicator in the display. Press again to cancel and return to horizontal text. Note: Vertical text is not available on multi-line labels. v e r t i c a l l y 4 LABEL LENGTH + SIZE Press to display the current label length. The length is normally calculated automatically, according to the length and size of the text on the label. The justify symbol will also be displayed. Press DEL to exit the length function without changing the length, or: Press JUST if necessary to select the justification required, as confirmed by the justify symbol in the display. or to increase (up to 5000mm max. ) or Use decrease the length in 2mm steps. The display will flash if you try to make the label shorter than the text. [. . . ] 5 PRINT CONTRAST -- may be adjusted by pressing SYMBOL + JUST followed by space key to display the contrast symbols <- l l l l l +>. Use or to select lighter or darker print. The normal contrast level is the mid-setting. Note: This function enables you to adjust the print quality under extreme temperature conditions. BARCODE BARCODES + VERT Barcodes can be printed on 19mm wide labels only and can be either full height or mixed with text on one or two lines. [. . . ]