User manual DYMO LABELPOINT 350

[. . . ] About Your New Labelmaker With your new DYMO LabelPOINTTM 350 labelmaker, you can create a wide variety of highquality, self-adhesive labels. You can choose to print your labels in many different sizes and styles. The labelmaker uses DYMO D1 label cassettes in widths of 6 mm (1/4"), 9 mm (3/8"), 12 mm (1/2"), or 19 mm (3/4"). Label cassettes are also available in a wide range of colors. [. . . ] Type the text for the first line, and press 7. A new line character is displayed at the end of the first line, but will not print on the label. The display shows the line on which you are currently entering text. The example below indicates that the second line is the current line on the label. Use the arrow keys to move between lines. To add a format break 1. Enter and format text for the first section. Select Insert Format Break and press OK . A new section character is displayed at the end of the first section, but will not print on the label. Continue entering and formatting text for the next section of the label. Using Tabs You can add tabs to a label to align text on multiline labels. Tabs are left justified and the default spacing is 50 mm (2. 0"). Use the up and down arrow keys to increase or decrease the tab setting, and then press OK . Press the key and continue entering text. Using Symbols and Special Characters Symbols and other special characters can be added to your labels. Using Mixed Formats You can apply different fonts and format styles to the text on a label by inserting format breaks to divide the label into blocks or sections of text. You can add two format breaks allowing you to apply three separate formats per label. Alignment, underline, box styles, and background patterns cannot be mixed on a label. These styles are common to the entire label. Adding Symbols The labelmaker supports the extended symbol set as shown in Figure 12. 8 To add a symbol 1. The first row of symbols shown in the table appears in the display. Use the arrow keys to move to the desired symbol. The left and right arrows move horizontally along a row of symbols. The up and down arrow keys scroll vertically through the rows of symbols. To quickly see a row of symbols, you can press the letter corresponding to the row you want. When you locate the desired symbol, press OK to add the symbol to your label text. Adding International Characters The labelmaker supports the extended Latin character set using RACE technology. Similar to using a mobile phone keypad, if you type a letter multiple times within a very short time, you will scroll through variations on that letter. [. . . ] The first memory location is displayed similar to storing a label or format. Select a label or format to recall and press OK . 12 Troubleshooting Review the following possible solutions if you encounter a problem while using your labelmaker. Problem/Error Message No display Poor Print Quality Solution · Ensure the labelmaker is turned on. · · · · Replace discharged batteries or attach power adapter. Ensure tape cassette is installed properly. [. . . ]