User manual DYMO RHINO 6000

[. . . ] User Guide www. dymo. com Tape Exit Backlight LCD display Power Cut/Feed Print/# of copies Hot Keys Library Barcode Symbol Clear Navigation keys OK Serialization Settings Backspace Enter Escape Size/CAPS Save/Insert Recall/Remove Shift USB connector Space bar Power connector Figure 1 RHINO 6000 LabelPrinter Contents About Your New Printer . 2 Inserting and Removing the Tape Cassette . 10 Printing Vertical Lines between Cells . 12 Using Simultaneous Serialization . [. . . ] Press OK and then Done (ESC) to return to the label. Changing the Label Type Once you create a label using one label type, you can easily change the label type without losing your data. When you change from a multi-cell label, such as a patch panel, to a single cell label, such as General or Flag, each cell becomes a new label. If the data from one label type will not fit in the new label type, the text that will not fit is shaded in the display. Press the hot key for the new label type. 9 2. Make any necessary adjustments to the settings for the label type. Changing the Label Settings Once you create a specific label, you can change the settings without starting all over again. The settings for the particular label type are displayed. Press OK and then select Done (ESC). The barcode prints horizontally along the label with the text in small print underneath the barcode. You can optionally add text before and after the barcode. Adding a Barcode The barcode text appears on the label in the display just like any other text. However, if the cursor is positioned within the barcode text, Barcode and the type of barcode are displayed in the Caption bar. Use the arrow keys to select the barcode type, and press OK. Enter the text for the barcode within the barcode and press OK. Printing Vertical Lines between Cells For multiple cell labels, such as Patch Panel, Terminal Block, and Module, you can choose to print a vertical line between each of the cells. To print vertical lines between cells 1. A vertical mark is printed between each cell. Editing a Barcode You edit an existing barcode or delete a barcode in the same manner. Move the cursor anywhere within the barcode text. A message appears asking if you would like to edit the barcode. The text of the existing barcode appears. Edit the barcode text and press OK. Using Barcodes The printer can generate the following types of barcodes. Code 39 Code 128 Auto UPC A EAN 8 EAN13 UPC E Deleting a Barcode A barcode is entered on the label as one character. Place the cursor at the end of the barcode on the display. Press . You can only print a barcode on 19 mm and 24 mm wide label tape. You can choose to print the humanreadable text or not, and you can serialize barcodes. Hiding Barcode Text You can choose to hide the human-readable text for the barcode. 10 To hide barcode text 1. Press OK and then select Done (ESC). Inserting User Symbols Custom symbols downloaded from RHINO Connect Software are stored as User symbols. See Using RHINO Connect Software on page 15 for more information. [. . . ] Self-Lam labels can only be printed on 24 mm Self-Laminated · Change the tape width. · Open the tape cassette lid and check that the tape is not jammed. · Pull a small amount of tape from the cassette to make sure the tape moves freely. · Press each key to determine which key is jammed. [. . . ]