User manual DYNACORD CLS 222 DATASHEET

[. . . ] A polarized plug has two blades with one wider than the other. A grounding type plug has two blades and a third grounding prong. The wide blade or the third prong are provided for your safety. I the provided plug does not fit into your outlet, consult an electrician for replacement of the obsolete outlet. [. . . ] Switch off all microphones that are not in use. Consider the microphones' different polar patterns and characteristics, when placing the monitor speakers. Do not turn up the monitor system's volume higher than actually necessary. Try to avoid extensive equalization on channels that you want to include in your monitor mix. Keep in mind, that a microphone "behaves" different when somebody stands right in front of it. If you still have the feeling that the monitor system's acoustic output is not sufficient, after considering the above mentioned precautions, you can use the FEEDBACK filter to mute the frequency that tends to generate feedback the most. Therefore, you have to perform the following steps: Increase the MON 1/2 level until the limit is reached where feedback starts. The slightly "hovering" sound that you hear is generated by the system itself. Switch on the feedback filter, turn the rotary control and set it at the mark where the "sound" disappears. Switching the filter on and off lets you easily check whether you tuned in the correct frequency. The feedback filter attenuates the level of the corresponding frequency band by about 9 dB. 55 - MASTER A INSERTS L/R Stereo phone jacks for left and right channels with breaker function. the low impedance output is assigned to the tip (send) and the high impedance input (return) is assigned to the ring of the connector. This jack allows incorporating external third octave band or octave band EQs, compressors, limiters, de-noisers, etc. As well as with the inserts of the monaural input channels, different DIRECT OUT functions can be accomplished. please , also refer to the corresponding description on page 7. 56 - MASTER B OUTPUTS L/R At the MASTER B OUTPUTS the L/R master audio signal is present that can be used for additional monitoring, side fill and "next door" applications, or for the connection of a delay-line or subwoofer. 58 - PRE/POST OF MASTER B When PRE is selected the MASTER B is outputted pre master faders (and, if used, pre GEQ), i. The level at the MASTER B OUTPUTS is independent from the master faders settings. When POST is selected the MASTER B is outputted post master faders, i. The level at the MASTER B OUTPUTS depends on the setting of the master faders. Controlling a connected Sub's level via master fader makes sense when using an active subwoofer. [. . . ] Establish a basic mix, using the channel faders, so that the individual sound levels relate to each other according to your personal taste. the best range for the channel faders to be set to is in the area of 5 dB to 0 dB. In this way you are provided with enough tolerance for later adjustments. Use the master faders to adjust the overall volume. [. . . ]