User manual DYNACORD D 11 A

[. . . ] Use only with the cart, tripod, bracket, or table specified by the manufacturer, or sold with the apparatus. When a cart is used, use caution when moving the cart/apparatus combination to avoid injury from tip-over. Unplug this apparatus during lightning storms or when unused for a long period of time. refer all servicing to qualified service personnel. [. . . ] The master signal can be daisy-chained to a second D 11A cabinet via a regular XLR microphone cable. The built-in level control VOLUME allows easy adjustment of the required sound pressure level. the D 11A is connected to the mains via a locked IEC inlet that guarantees a hassle-free operation. Extremely durable acoustic foam mounted to a strong powder-coated steel grille protects the loudspeaker components against any mechanical damage. CAUTION: Do not ship the cabinet in any other than its original packaging. When shipping the cabinet make sure to always use its original box and packaging materials. HINT: This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instruction manual, may cause harmful interference to radio communications. Operation of this equipment in a residental area is likely to cause harmful interference in which case the user will be required to correct the interference at his own expense. NOTES: This equipment has been tested and found to comply pursuant to the product family standard for audio professional use according EMC Directive 2004/108/EC: EN55103-1 and EN55013-2 standards (with the limits for E4 and E5 electromagnetic environment); EN61000-3-2, EN61000-3-3. Carefully open the packaging and take out the cabinet. Inspect the cabinet's enclosure for damages that might have occured during transportation. Each cabinet is examined and tested in detail before leaving the manufacturing site to ensure that it arrives in perfect condition at your place. Please inform the transport company immediately if the cabinet shows any damage. Being the addressee, you are the only person who can claim damages in transit. Keep the cardboard box and all packaging materials for inspection by the transport company. Keeping the cardboard box including all packing materials is also recommended, if the cabinet shows no external damages. Description Limit indicator (LIMIT) Master level control (VOLUME) Power on/off indicator (POWER) Mains switch (ON / OFF) Microphone level control (MIC GAIN) Mains connector, lockable (MAINS IN) Aux level control (AUX LEVEL) Input connector (RCA) for stereo aux signal (AUX IN L/R) Mode selection switch (LO-CUT / FULLRANGE) Input connector for microphone level audio signal (MIC IN) Line level control (LINE TRIM) Input connector (XLR or phone) for line level audio signal (LINE IN) Output connector (XLR) for line level audio signal (LINE THRU) Output connector (XLR) for master audio signal (MASTER OUT) 1 LIMIT INDICATOR (LIMIT) Brief blinking of the LIMIT LED indicates that the power amplifier of the D 11A is operated at its limits. CAUTION: Before connecting or unplugging an appliance, make sure to turn the AUX LEVEL control all the way down (counterclockwise). 9 MODE SELECTION SWITCH (LO-CUT/FULLRANGE) If the D 11A is used as a fullrange system, select FULLRANGE (button not pressed). if a subwoofer is available , select LO-CUT (button pressed) for activating the internal low-cut filter. [. . . ] CAUTION: After installing the system, first switch on the mixing console and position the mixer's master faders to their minimum settings. That followed, switch on the D 11A and use the master faders to adjust the desired volume setting. Otherwise, high sound levels caused by unintentional playback of a program source could be the result, which might cause hearing damage. Adjust the input channel's `Gain` control so that the Peak LED should not light at all or blink only once in a while. [. . . ]