User manual DYNACORD DSP 600

[. . . ] The lightning flash with arrowhead symbol, within an equilateral triangle is intended to alert the user to the presence of uninsulated "dangerous voltage" within the product's enclosure that may be of sufficent magnitude to constitute a risk of electric shock to persons. install in accordance with the manufacturer's instructions. Do not install near heat sources such as radiators, heat registers, stoves, or other apparatus (including amplifiers) that produce heat. Do not defeat the safety purpose of the polarized or the grounding-type plug. [. . . ] Use the VALUE up/down buttons to edit the IP address of the DSP 600. Following table shows the default values of the ethernet interface. Use the VALUE up/down buttons to choose your editing preferences. The Link, Id and Mask parameters (see following table) are used for linking parameters of DSP 600 devices connected via Ethernet. Parameter Link Default off Description The link setting only works if more than one DSP 600 device is connected to an ethernet. Devices that are Master or Slave have always idential parameter settings. Select , , Master", if this DSP 600 should write the parameter settings to one or more other DSP 600 (Slave). Select , , Slave", if the parameter settings of this DSP 600 should be read from another DSP 600 (master). Select , , off", if the parameter settings of this DSP 600 should be independent from other devices. Each master DSP 600 connected to the ethernet must have an unique network id. Enter the id of the Master DSP 600 the parameters should be read from if this DSP 600 is used as , , Slave". Description If the Link , , Slave" is selected, choose the parameter groups that this DSP 600 should read from the Master DSP 600. Following groups are available: · PARAMETER UNITS This window allows selecting the unit used for temperature and the limiter threshold. The parameter Temp is used to calculate the speed of sound for converting delay times into distance. use the < SELECT > buttons to navigate to the Temp and Units parameters. Use the VALUE up/down buttons to choose between -4. Use the VALUE up/down buttons to choose dBu (DSP output) or Vpk (Amp output). Sound travels at different speeds depending on the density of the surrounding air it is traveling through. Cold air is denser than warm air thus, travels slower than it would if the air was warmer. Temperature can have a major influence with greater distances, particularly with respect to widely separated speaker arrays surrounding the audience for example. Temperatures might vary wildly between an indoor environment and an outdoor evening environment for example. 6m/s/C) * T The speed of sound at room temperature is 346 meters per second. [. . . ] Crossover channels are fed from IN A, full range channels are fed from IN B. In this configuration, all 6 outputs are configured for full range operation. OUT 1, OUT 2 and OUT 3 get their signal-feed from IN A while OUT 4, OUT 5 and OUT 6 are fed from the input channel IN B. This configuration provides a "blank slate" for creating any custom routing and processing application. [. . . ]