User manual DYNACORD ELAN DATASHEET

[. . . ] Arrangements are made with the dealer where you purchased the equipment from, for the returning of all unusable equipment at no cost, to the factory in Straubing, for environmental protective disposal. The lightning flash with arrowhead symbol, within an equilateral triangle is intended to alert the user to the presence of uninsulated "dangerous voltage" within the product's enclosure that may be of sufficent magnitude to constitute a risk of electric shock to persons. install in accordance with the manufacturer's instructions. Do not install near heat sources such as radiators, heat registers, stoves, or other apparatus (including amplifiers) that produce heat. [. . . ] Take your time to test all presets and select the ones that are best suited for your specific application. Program number "0" selects a Slap Back Echo, which is mainly for servicing and testing only, and therefore is not included in the effects listing on the front panel. also provided is a FOOTSWITCH connector , which allows the connection of a footswitch pedal to remotely control the FX units' EFFECT ON/OFF function. If your footswitch features a LED ­ like the optionally available DYNACORD FS 11 does ­ this indicator will light when the effect is activated (EFFECT ON). Changing FX Start Programs In the factory shipping state, the FX units start with the programs 5/55. If you prefer different programs, you can change and store the new settings in the programming mode. to assign new start programs , please proceed as follows: 1. Hold down the two DOWN buttons of FX1 and FX2 simultaneously while switching on the PowerMate. Release the two DOWN buttons and select the desired start programs. Press the two UP buttons to store the displayed effect numbers as your new start programs. The FX unit acknowledges the save procedure by briefly indicating "Prog" on the display. Using the AUX3/4 fader allows setting the output level in a wide range up to +20dBu. The AUX3/4 SEND is designed in Ground Sensing technology to prevent the induction of external noise, even with long cables. Use balanced cables for the connection of external components whenever it is possible. AUX3/4 POST As already previously described, this switch allows determining whether Pre- or Post-Fader signals are present at the AUX3/4 channel. The corresponding yellow LED signals when the switch is engaged and all input channel AUX3/4 controls are assigned post fader. FEEDBACK FILTER The feedback filter is a very narrow banded notch filter, which is only active in a range that is extremely susceptible for acoustical feedback. Several circumstances and conditions have an influence on how sensitive or insensitive your system is for acoustical feedback. The following notes are meant to assist you in avoiding feedback and you should take them into consideration even before you activate the feedback filter: 1. Do not position the main speaker systems behind the microphones. Switch off all microphones that are not in use. Consider the microphones' different polar patterns and characteristics, when placing the monitor speakers. [. . . ] And for the rest, we like to wish you lots of fun and success with your new PowerMate mixer. The patch field within the master section is referred to as MASTER PATCHBAY The mixer's Line output levels, return and insert connections are to be found here. To provide you with a wide range of connection possibilities, the MASTER INSERTS, MAIN OUTPUTS, EQ INPUTS and EQ OUTPUTS, POWER AMP INPUTS, and the AUX SENDS and AUX RETURNS can be independently connected with each other or routed to external devices. In the basic configuration ­ when no plugs are inserted into any of the MASTER INPUT connectors ­ signals are patched internally and fed to the internal power amplifier. [. . . ]