User manual DYNASTY SPAS CLASSIC MC-MP-DY4 SPA PACK-JUNE 05

[. . . ] Pressing again turns fiber box motor off but leaves light on. A third time turns both motor and light off. A built-in timer turns fiber box off after 2 hours, unless it has been manually deactivated. The "Light" icon is displayed when fiber box light is on. [. . . ] It flashes when there is a request for more heat but the heater has not yet started. The filter cycle is suspended if the water temperature raises more than 2°F (1°C) above Set Point or if a pump has been started manually. The "Filter" icon will blink (on 0. 5 second, off 0. 5 second, on 0. 5 second, off 1. 5 seconds). Troubleshooting Setting water temperature: Use Up or Down arrow key to regulate water temperature. The temperature setting will be displayed for 5 seconds to confirm your new selection. The "Set Point" symbol indicates the desired temperature, NOT the current water temperature!Water temperature can be adjusted by 1° increments from 59 to 104°F (15 to 40°C). Pumps have started up for one minute on several occasions and "Filter Cycle" icon is flashing. Our Smart Winter Mode protects your system from the cold by automatically turning the pumps on for one minute several times a day to prevent water from freezing in pipes. Press any key to reset the system, then reprogram all desired parameters. Water temperature is displayed. Water temperature in the spa has reached 112°F (44°C). The system will reset automatically when water reaches 109°F (43°C). Call your dealer or service supplier if problem persists. 3 flashing dots are displayed. Shut power off and power your spa up again to reset the system. Call your dealer or service supplier if problem persists. Inverted display: Press and hold Pump 2 for 5 seconds to invert the display. Note that the °F or °C icon is not displayed in reverse mode. Follow the same procedure to return to default mode. If a power-up occurs, the display always returns to default mode. Quick Reference Card 7 Step 1 Step 2 Step 3 Step 4 Step 5 Step 6 Step 7 Step Programming Sequence Time of day Filter cycle start time Filter cycle duration Filter cycle frequency Economy mode start time Economy mode duration Storing settings in memory & returning to Normal mode Filter Cycle icon Programming Mode icon Temperature unit Heater icon Up & Down arrows Economy Mode Lock icon icon Step 1- Time of day Setting the time: 10:25 am 11:43 pm Digital control pad lockout This function allows you to prevent unauthorized parameter setting of the unit. This feature is especially helpful when young children have access to the keypad. There are two modes you can choose from: Full lock or Partial lock. Full lock means that all keypad functions are locked. Partial lock means that the basic functions of the spa will remain accessible (pumps, blower and light), but it will be impossible to change the temperature Set Point, to override the Economy mode or to enter the Programming mode. When control pad is locked, the "Lock" icon will be displayed. Locking your digital control pad: 1- Press and hold Pump 1 key for 5 seconds. 2- The display will show LocP, with "P" representing Partial lock. [. . . ] 2- The display will show Fdxx, with "xx" representing the duration in hours. 3- Use Up and Down arrows to change setting. Step 4- Filter cycle frequency Setting filter cycle frequency: FF01 FF04 1- Press Prog. 2- The display will show FFxx, with "xx" representing the frequency per day. 3- Use Up and Down arrows to change setting. Steps 5 & 6- Economy mode start time & duration* Setting Economy mode start time: ES10 ES08 noEc Ec 1 1- Press Prog. [. . . ]