User manual DYNASTY SPAS CLASSIC SINGLE PUMP

[. . . ] It flashes when light is on at low intensity. Fiber Box Option: If spa has an optional fiber box only, pressing Light key turns fiber box (motor & light) on. Pressing again turns fiber box motor off but leaves light on. A third time turns both motor and light off. [. . . ] A built-in timer automatically turns pump off after 20 minutes, unless manually desactivated first. Starting the blower: Press Blower to turn blower on at high speed. Press a second time to turn blower to low speed. A built-in timer turns blower off after 20 minutes, unless manually deactivated first. The "Blower" icon lights up when blower is on at high speed. It flashes when blower is on at low speed. Pumps have started up for one minute on several occasions and "Filter Cycle" icon is flashing. Our Smart Winter Mode protects your system from the cold by automatically turning the pumps on for one minute several times a day to prevent water from freezing in pipes. Press any key to reset the system, then reprogram all desired parameters. Water temperature is displayed. Water temperature in the spa has reached 112°F (44°C). The system will reset automatically when water reaches 109°F (43°C). Call your dealer or service supplier if problem persists. 3 flashing dots are displayed. Shut power off and power your spa up again to reset the system. Call your dealer or service supplier if problem persists. Temperature display unit: Press and hold Light key for 5 seconds to display water temperature in either Fahrenheit (°F) or Celsius (°C). Quick Reference Card 7 Step 1 Step 2 Step 3 Step 4 Step 5 Step 6 Step 7 Step Programming Sequence Time of day Filter cycle start time Filter cycle duration Filter cycle frequency Economy mode start time Economy mode duration Storing settings in memory & returning to Normal mode Filter Cycle icon Programming Mode icon Temperature unit Heater icon Up & Down arrows Economy Mode Lock icon icon Step 1- Time of day Setting the time: 10:25 am 11:43 pm Digital control pad lockout This function allows you to prevent unauthorized parameter setting of the unit. This feature is especially helpful when young children have access to the keypad. There are two modes you can choose from: Full lock or Partial lock. Full lock means that all keypad functions are locked. Partial lock means that the basic functions of the spa will remain accessible (pumps, blower and light), but it will be impossible to change the temperature Set Point, to override the Economy mode or to enter the Programming mode. When control pad is locked, the "Lock" icon will be displayed. Locking your digital control pad: 1- Press and hold Pump 1 key for 5 seconds. 2- The display will show LocP, with "P" representing Partial lock. 3- Release the key and the keypad will be in Partial lock mode. Keep key pressed down for 5 more seconds if you want to be in Full lock mode. The "LocF" message will then be displayed. 1- Enter Programming mode by holding Prog. [. . . ] 3- Use Up and Down arrows to change setting. Steps 5 & 6- Economy mode start time & duration* Setting Economy mode start time: ES10 ES08 noEc Ec 1 1- Press Prog. 2- The display will show ESxx, with "xx" representing the starting hour. 3- Use Up and Down arrows to change setting. After 5 seconds, the new setting will be programmed. Inverted display Press and hold Pump 2 for 5 seconds to invert the display. Note that the °F or °C icon is not displayed in reverse mode. [. . . ]