User manual DYNASTY SPAS EXCALIBUR-MC-MP-CE SPA PACK QUICK REFERENCE CARD

[. . . ] The "Light" indicator is displayed when light is on at high intensity. It flashes when light is on at low intensity. Fiber Box Option: If your spa has an optional fiber box, press Light key to turn fiber box (motor & light) on. Press a second time to turn fiber box motor off and leave light on. [. . . ] Press and hold Filter key for 5 seconds to turn the system down (i. e. to set it to Standby mode) for 60 minutes. The display toggles between "SBY" message and the time remaining. All keys are then disabled, unless you press Filter key to reactivate the system before the expiration of the 60-minute delay. Troubleshooting Automatic water heater start: When water temperature is 0. 5°C (1°F) lower than the Set Point, the heater will automatically turn on until water temperature reaches Set Point plus 0. 5°C (1°F). The "Heater" indicator lights up when the heater is on. It flashes when there is a request for more heat but the heater has not yet started. Note: The heater will not start if two pumps or more are running at high speed. Pumps have started up for one minute on several occasions and "Filter Cycle" icon is flashing. Our Smart Winter Mode protects your system from the cold by automatically turning pumps on for one minute several times a day to prevent water from freezing in pipes. Press any key to reset the system. Water temperature is displayed. Water temperature in the spa has reached 44°C (112°F). The system will reset automatically when water reaches 43°C (109°F). Call your dealer or service supplier if problem persists. 3 flashing dots are displayed. Shut power off and power your spa up again to reset the system. Call your dealer or service supplier if problem persists. Setting water temperature: Use Up or Down arrow key to regulate water temperature. The temperature setting will be displayed for 5 seconds to confirm your new selection. The "Set Point" symbol indicates the desired temperature, NOT the current water temperature!Water temperature can be adjusted by 0. 5°C or 1°F increments from 15 to 40°C (59 to 104°F). Quick Reference Card K-4 keypad is mandatory when some options are selected. * Filter cycles The system automatically performs 2 filter cycles per day, at 12hour intervals. During a filter cycle, Pumps 2 & 3 and blower run for one minute. Pump 1 then runs at low speed for the remaining of the cycle and "Filter Cycle" icon lights up. (If system is equipped with a circulation pump, all pumps and blower run for one minute. Circulation pump then runs for the remaining of the cycle and "Filter Cycle" icon lights up. ) Setting filter cycles: FD10 Digital control pad lockout This function allows you to prevent unauthorized parameter setting of the unit. [. . . ] 5- The display will show ESxx, with "xx" representing the delay before mode starts. 6- Use Up and Down arrows to change setting. 7- Press Econo key a third time to store settings. "CLE" message Every two weeks, the "CLE" message might be displayed indicating to clean the filter (depending on your spa configuration). Press any key to reset the message. 40-minute Economy mode time-out: If you turn a pump, blower or light on while Economy mode is on, the Economy mode will be interrupted and will only resume 40 minutes after the system has turned the last active output off. [. . . ]