Lastmanuals offers a socially driven service of sharing, storing and searching manuals related to use of hardware and software : user guide, owner's manual, quick start guide, technical datasheets... DON'T FORGET : ALWAYS READ THE USER GUIDE BEFORE BUYING !!!
If this document matches the user guide, instructions manual or user manual, feature sets, schematics you are looking for, download it now. Lastmanuals provides you a fast and easy access to the user manual DYNATEK D2K-HD2E. We hope that this DYNATEK D2K-HD2E user guide will be useful to you.
Lastmanuals help download the user guide DYNATEK D2K-HD2E.
Detailed instructions for use are in the User's Guide.
[. . . ] Repeat this using the other connector pair and the rear cylinder injector.
STEP 3
Locate the TPS connector behind the throttle body.
STEP 3
TPS Connector
STEP 2
Part# D2K-HD2E
2
Installation
STEP 4
Unplug the connector from the TPS. Crimp the wire tap onto the wire that is grey with a purple stripe. This wire should be in position "C" on the connector. [. . . ] This wire should be in position "C" on the connector. Plug the grey wire from the FI Controller into the wire tap.
STEP 5
STEP 5
Run the wiring harness for the FI Controller from the engine to the seat. Make sure that it will not get damaged when you reinstall the tank. Use one of the wire ties to tie the wires to the frame, away from the cylinder head.
STEP 4
FI Controller
STEP 6
Reinstall fuel tank and seat.
STEP 6
Place the FI Controller where you plan on mounting it permanently. In most cases, this will be under the seat. Connect the ground lug (black wire) to a grounding point on the bike. Use the Velcro tape to mount the FI Controller in position. Use alcohol swab to clean mounting surface prior to attaching Velcro.
Part# D2K-HD2E
3
Controls
The FI Controller is preprogrammed with 4 base fuel curves. This should make the bike run better at all RPMs. The AF ratio if measured on a dyno should be much smoother throughout the RPM range than without the FI Controller. If it feels worse or the AF ratio gets too lean at any RPM compared to stock, try a different curve. Once you have selected the correct curve, then you can fine tune any problems with the map by using the potentiometers. With the arrows on the pot straight up and down, the pots are at 0% adjustment. To add more fuel, turn the pots clockwise. To subtract fuel, turn the pots counterclockwise. Do not attempt to adjust while riding!
Troubleshooting
If the STATUS LED does not come on when the ignition is switched on, there is no power to the FI Controller. [. . . ] To subtract fuel, turn the pots counterclockwise. Do not attempt to adjust while riding!
Troubleshooting
If the STATUS LED does not come on when the ignition is switched on, there is no power to the FI Controller. Make sure that you have the ground hooked up properly either directly to the battery ground, or to a lug on the frame that is grounded. [. . . ]
DISCLAIMER TO DOWNLOAD THE USER GUIDE DYNATEK D2K-HD2E
Lastmanuals offers a socially driven service of sharing, storing and searching manuals related to use of hardware and software : user guide, owner's manual, quick start guide, technical datasheets... In any way can't Lastmanuals be held responsible if the document you are looking for is not available, incomplete, in a different language than yours, or if the model or language do not match the description. Lastmanuals, for instance, does not offer a translation service.
Click on "Download the user manual" at the end of this Contract if you accept its terms, the downloading of the manual DYNATEK D2K-HD2E will begin.