User manual DYSON AIRBLADE AB03 TECHNICAL SPECIFICATION

[. . . ] This product may contain ZPL®, ZPL II®, and ZebraLinkTM programs; Element Energy Equalizer® Circuit; E3®; and Monotype Imaging fonts. ZebraLink and all product names and numbers are trademarks, and Zebra, the Zebra logo, ZPL, ZPL II, Element Energy Equalizer Circuit, and E3 Circuit are registered trademarks of ZIH Corp. All other brand names, product names, or trademarks belong to their respective holders. For additional trademark information, please see "Trademarks" on the product CD. Proprietary Statement This manual contains proprietary information of Zebra Technologies Corporation and its subsidiaries ("Zebra Technologies"). [. . . ] Press PLUS (+) or MINUS (-) to scroll through the options. Press SELECT to accept any changes and deselect the parameter. 9/18/07 Z4Mplus/Z6Mplus User Guide 13163L-002 A 94 Configuration Control Panel Parameters Table 11 · Printer Parameters (Page 13 of 22) Parameter Action/Explanation DATA BITS - 8 BITS Set Data Bits The data bits of the printer must match the data bits of the host computer for accurate communications to take place. Set the data bits to match the setting being used by the host computer. Note · Code Page 850 requires the data bits to be set to 8 bits. See the ZPL II Programming Guide for more information. Default: 8 BITS Selections: 7 BITS, 8 BITS To change the value shown: 1. Press PLUS (+) or MINUS (-) to toggle between the options. Press SELECT to accept any changes and deselect the parameter. PARITY NONE + Set Parity The parity of the printer must match the parity of the host computer for accurate communications to take place. Select the parity that matches the one being used by the host computer. Default: NONE Selections: EVEN, ODD, NONE To change the value shown: 1. Press PLUS (+) or MINUS (-) to scroll through the options. Notes on diagnostic printouts are defined as follows: · FE indicates a framing error. Default: NORMAL MODE Selections: NORMAL MODE, DIAGNOSTICS To change the value shown: 1. 4. Press SELECT to select the parameter. Press PLUS (+) or MINUS (-) to toggle between the options. For any errors, check that your communication parameters are correct. Set the print width equal to or less than the label width used for the test. See Set Print Width on page 85 for more information. Press SELECT to accept any changes and deselect the parameter. CONTROL PREFIX < >7EH + Set Control Prefix Character The printer looks for this two-digit hex character to indicate the start of a ZPL/ZPL II control instruction. The "H" that is displayed indicates Hexadecimal and is not part of the value. Note · Do not use the same hex value for the control, format, and delimiter character. The printer must see different characters to work properly. [. . . ] You irrevocably agree to submit to the exclusive jurisdiction and venue of the state or federal courts in the State of Illinois in the event of any litigation involving this Agreement or the Software. You agree that you shall not assert any claim that you are not subject to the jurisdiction of such courts, that the venue is improper, that the forum is inconvenient or any similar objection, claim or argument. Zebra may, in its sole discretion, choose to resolve any controversy or dispute between you and Zebra concerning this Agreement, or the existence, validity, breach or termination thereof, whether during or after the term by binding arbitration in accordance with the Commercial Arbitration Rules of the American Arbitration Association ("AAA"), as modified or supplemented under this Section 15, by providing notice to you. In the event that Zebra provides such notice, you hereby waive any right to institute a court or other dispute resolution proceeding with respect to such controversy or dispute and acknowledge arbitration in accordance with this Section 15 as the sole and exclusive means of resolving such controversy or dispute. [. . . ]