User manual DYSON DC24 ALL FLOOR

[. . . ] Ensure all parts including clear binTM are securely attached before use or carrying the machine. This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety. Children should be supervised to ensure that they do not play with the appliance. Unplug from outlet when not in use, and before performing user maintenance, connecting or disconnecting the hose or changing accessories. [. . . ] Do not use detergents, polishes or air fresheners to clean the bin. When vacuuming, certain carpets may generate small static charges in the clear binTM. These are entirely harmless and are not associated with the mains supply. To minimise any effect from this, do not put your hand or insert any object into the clear binTM unless you have first emptied it and rinsed it out with cold water. THIS APPLIANCE IS INTENDED FOR NORMAL DOMESTIC USE ONLY SAVE THESE INSTRUCTIONS Using your Dyson Press foot pedal and recline handle to use. The stabiliser stand will automatically lift up. To switch `ON', depress power button in front of handle. When finished cleaning, push machine into an upright position and stabiliser wheels will automatically drop. Use the carrying handle to carry the machine. Caution: (i) (ii) When returning to the upright position, ensure that the stabiliser wheels are fully engaged before releasing the cleaner. Do not press the cyclone release button while carrying the machine or it could fall and cause injury. Fine dust such as plaster or flour should only be vacuumed in very small amounts. Consult your flooring manufacturer's recommended instructions before vacuuming and caring for your flooring, rugs and carpets. Some carpets will fuzz if a rotating brushbar is used when vacuuming. If this is the case, we recommend vacuuming in hard floors mode and consulting with your flooring manufacturer. (See `Hard floors or carpets' section. ) If used in a garage for car cleaning, care should be taken to wipe the soleplate and wheels with a dry cloth after vacuuming to clean off any sand, dirt, or pebbles which could damage delicate floors. Please note: Please note: (i) (ii) Washing your filters Caution: (i) Switch `OFF' before removing the filters. (ii) Ensure filters are completely dry before refitting to machine. This machine has two filters, located as shown. It is important to check your filters regularly and wash at least every month according to instructions, to maintain performance. The filter in the ball should be rinsed and tapped out until the water runs clean, then tapped out again to ensure all excess water is removed. This will normally require up to 10 rinse cycles. Please leave to dry completely for 24 hours. Please note: (i) (ii) (iii) It is normal for the filter in the ball to turn grey in colour. [. . . ] The British Allergy Foundation Seal of Approval is a UK-registered trademark. Please note: (i) Do not use the machine without the clear binTM in place. Clearing brushbar obstructions Caution: (i) Switch `OFF' and unplug machine before clearing brushbar obstructions. If your brushbar is obstructed, it may shut off. If this happens you will need to remove brushbar as shown and clear any obstructing debris. Conformity information: A sample of this product has been tested and found to conform with the following European Directives: 2006/95/EC Low voltage Directive, 2004/108/EC EMC Directive, 93/68/EEC CE Marking Directive. [. . . ]