User manual DYSON DC42

[. . . ] OPERATING MANUAL GUIDE D’UTILISATION ASSEMBLY ASSEMBLAGE clik WASH FILTERS Wash filters with cold water at least every month. IMPORTANT SAFETY INSTRUCTIONS BEFORE USING THIS APPLIANCE READ ALL INSTRUCTIONS AND CAUTIONARY MARKINGS IN THIS MANUAL AND ON THE APPLIANCE When using an electrical appliance, basic precautions should always be followed, including the following: WARNING 1. TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK, OR INJURY: This Dyson appliance is not intended for use by young children or infirm persons with reduced physical, sensory or reasoning capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction by a responsible person concerning use of the appliance to ensure that they can use it safely. Close attention is necessary when used by or near children. [. . . ] To refit: – f it the cyclone shroud into the clear bin so that the silver button clicks  and engages – close the clear bin base so it clicks into place – push the cyclone and clear bin unit into the main body of the appliance;  it will click into place – ensure the cyclone and clear bin unit are secure. ATTACHMENTS • • To release the wand, open the wand cap and pull the red tube up and away from the handle until it clicks into place. Should you wish to use the hose without the wand, follow the above instruction and press the red button to release the wand from the hose. CARPETS OR HARD FLOORS • • • The brush bar will always default to ‘ON’ (spinning) each time you switch the appliance ‘ON’ and recline it for cleaning. The brush bar will not rotate when the appliance is upright. For delicate rugs and hard floors): – switch the appliance ‘ON’ – recline the appliance – press the brush bar ‘ON/OFF’ button – the brush bar will stop spinning. Before vacuuming your flooring, rugs and carpets, check the manufacturer’s recommended cleaning instructions. Some carpets may fuzz if a rotating brush bar is used when vacuuming. If this happens, we recommend vacuuming in ‘hard floor’ mode and consulting with the flooring manufacturer. The brush bar on the appliance may damage some carpet types. If you are unsure, turn off the brush bar. • • • • • • • • • • • WASHING YOUR FILTERS • • • • • • • • • Your appliance has two washable filters , located as shown. Check and wash the filters regularly according to instructions to maintain performance. Switch ‘OFF’ and unplug before checking or removing the filters. The filters may require more frequent washing if vacuuming fine dust. Do not put the filters in a dishwasher, washing machine, tumble dryer, oven, microwave or near an open flame. After washing lie the filter on its side and leave at least 24 hours to dry completely before refitting. To remove filter A see the ‘Wash filters’ section in this Dyson Operating Manual. To remove filter B: – turn the central locking dial on the outer cover of the ball counter-clockwise  until the cover is released – lift off the cover – turn the filter one-quarter counter-clockwise to release. Filter B should be rinsed and tapped out until the water runs clean, then tapped out again to ensure all excess water is removed. Leave to dry completely for 24 hours. It is normal for the filter in the ball to turn grey in colour. [. . . ] If your Dyson appliance needs service, call the Dyson Helpline so we can discuss the available options. If your appliance is under warranty, and the repair is covered, it will be repaired at no cost. IMPORTANT DATA PROTECTION INFORMATION Your details will be held by Dyson Canada Limited or others on behalf of Dyson Canada Limited so that we can assist you more quickly in our Dyson Helpline. From time to time, Dyson Canada Limited may send you special offers and news of our latest innovations. [. . . ]