User manual DYSON DC43

[. . . ] OPERATING MANUAL GUIDE D’UTILISATION ASSEMBLY ASSEMBLAGE clik WASH FILTERS Wash filters with cold water at least every 3 months. TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK, OR INJURY: This Dyson appliance is not intended for use by young children or infirm persons with reduced physical, sensory or reasoning capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction by a responsible person concerning use of the appliance to ensure that they can use it safely. Close attention is necessary when used by or near children. Children should be supervised to ensure that they do not play with the appliance. [. . . ] Wind the cord counter-clockwise around the cord hooks. To watch a short online video visit: www. Ca/DC43gettingstarted EMPTYING THE CLEAR BIN • • • • • • • • Switch ‘OFF’ and unplug before emptying the clear bin. Empty as soon as the dirt reaches the level of the MAX mark – do not overfill. To remove the cyclone and clear bin unit, press down on the red button at the rear of the carrying handle on the cyclone. To release the dirt, press all the way down on the red button at the rear of the carrying handle on the cyclone. To minimize dust/allergen contact when emptying, encase the clear bin tightly in a plastic bag and empty. To refit: – close the clear bin base so it clicks into place –  ush the cyclone and clear bin unit into the main body of the appliance; p it will click into place – ensure the cyclone and clear bin unit is secure. Detach the red ‘C’ clip which is on the connection between the cleaner head and the appliance. It is quite firm, but do not pull it off roughly. Pull the cleaner head away from the appliance. On the cleaner head are two dials: turn each a quarter-turn counter-clockwise until it clicks. Put the cleaner head onto its back: – lift up the top edge of the base plate, so it rotates to the upright position – lift out. beware of sharp objects when clearing obstructions. To refit the base plate: – f it the 3 lugs on the lower edge of the base plate into the 3 slots in the base of  the cleaner head – swing the upper edge of the base plate down; it will click into place. To secure the base plate: – press the base plate close to the cleaner head – secure the first dial by turning it a quarter-turn clockwise until it clicks  and engages – repeat with the second dial. Refit the red ‘C ‘clip onto the cleaner head. The flatter edge of the clip fits against the cleaner head. It is easier to slide one lug into its slot before the other. Attach the cleaner head by sliding it on to the connections on the lower front part of the ball. Ensure the electrical plug on the cleaner head fits into the twin-block connection on the body of the appliance, which is directly above the airway. Push firmly: the cleaner head will click into place. [. . . ] Complete the enclosed Warranty Form and mail it to us. This will confirm ownership of your Dyson appliance in the event of an insurance loss, and enable us to contact you if necessary. IMPORTANT DATA PROTECTION INFORMATION Your details will be held by Dyson Canada Limited or others on behalf of Dyson Canada Limited so that we can assist you more quickly in our Dyson Helpline. From time to time, Dyson Canada Limited may send you special offers and news of our latest innovations. [. . . ]