User manual EAGLE INTELLIMAP 500C Operation Instruction

[. . . ] 988-0156-051 www. eaglesonar. com Mapping GPS Receiver Installation and Operation Instructions Copyright © 2004 LEI-Eagle. No part of this manual may be copied, reproduced, republished, transmitted or distributed for any purpose, without prior written consent of Eagle Electronics. Any unauthorized commercial distribution of this manual is strictly prohibited. Eagle and IntelliMap are registered trademarks of LEI. [. . . ] GPS Data Files stored on an MMC must be copied from the card to the unit's internal memory before the unit can read them. Press MENU|MENU| to SYSTEM SETUP|ENT| to TRANSFER MY DATA|ENT and the screen below appears. 53 The Transfer My Data submenu asks if you want to save data to the MMC or load data from the MMC into the unit's memory. 2. The Transfer My Data menu includes a message which tells you if an MMC is present or not. If no MMC is present, you must first insert a card into the unit in order to activate the Load or Save commands. To transfer data from the unit to the MMC: press ENT (for SAVE. ) To transfer data from the MMC to the unit: press to LOAD|ENT. Saving to MMC: To accept the default name "Data" for the GPS Data File, press to SAVE DATA|ENT. If you wish to rename the file (as shown in the following figures), press ENT to activate the selection box. Press or to change the first character, then press to the next character and repeat until the name is correct. Then, press ENT| to SAVE DATA|ENT. The unit will display first a progress then a completion message when the data transfer is finished. To return to the Page view, repeatedly press EXIT. From left to right, these figures show the menu sequence for naming and saving a GPS Data File from the unit's memory to an MMC. 54 4. Loading to unit memory: There may be more than one GPS Data File (*. USR) on the card. To select a file, press ENT to activate the selection box, use or to highlight the file, then press ENT to accept the selection. The unit will display a completion message when the data transfer is finished. To return to the Page view, press EXIT|EXIT|EXIT|EXIT. Figure 1. Figure 2. Figure 3. Figure 4. These figures show the menu sequence for loading a GPS Data File from an MMC into the unit's memory. Cancel Navigation You can turn off any of the navigation commands after you reach your destination or at any other time by using the Cancel Navigation command. Press MENU|MENU| to CANCEL NAVIGATION|ENT| to YES|ENT. 55 Notes 56 Section 4: Advanced GPS Operations Find Distance From Current Position To Another Location 1. While on the Map Page press: MENU| to FIND DISTANCE|ENT. Center your cursor over the position you want to find the distance to. A rubber band line appears, connecting your current position to the cursor's location. The distance along that line will appear in a pop-up box. The box also shows the bearing to the point you're measuring to. Press EXIT|EXIT to return to regular operation. At left, the distance from the boat's current position to the cove is 5. 78 miles. [. . . ] We reserve the right to do so without notice. . . . in Canada: If you're in Canada and you have technical, return or repair questions, please contact the Factory Customer Service Department. Before any product can be returned, you must call customer service to determine if a return is necessary. Many times, customer service can resolve your problem over the phone without sending your product to the factory. To call us, use the following toll-free number: 905-629-1614 (not toll-free) 8 a. m. [. . . ]