User manual EAGLE INTELLIMAP 640C Operation Instruction

[. . . ] 988-0143-881 www. eaglesonar. com Mapping GPS Receiver Installation and Operation Instructions Copyright © 2005 LEI-Eagle. No part of this manual may be copied, reproduced, republished, transmitted or distributed for any purpose, without prior written consent of Eagle Electronics. Any unauthorized commercial distribution of this manual is strictly prohibited. Eagle and IntelliMap are registered trademarks of LEI. [. . . ] Press |ENT. 49 Figure 1. Figure 2. Figure 3. Figure 4. Navigate a trail menu sequence: Fig. 4, Edit Route Menu with Navigate Route command highlighted for Trail 2. A trail is always converted to a route when you navigate the trail. On the Map Page, the trail you are navigating is represented by a magenta line when the visible trail option is on. The course you are following is represented by a red line. The magenta trail line overlays the red course line. To see the red course line, you much turn off the visible trail option. The Navigation Page will show only the red course line, unless you are recording a new trail. The bearing arrow on the compass rose points to the next waypoint on the trail. As you travel, the arrival alarm will go off when you near a trail waypoint, and the bearing arrow on the compass rose will swing around and point to the next trail waypoint. Press EXIT to clear the alarm. 50 North Present position arrow Magenta trail line Trail point Navigate trail: Driver (left) is heading southeast straight toward trail point 3. Driver (right) has reached point 3 and has turned southwest to follow the trail. Track or compass heading indicator Bearing arrow Trail waypoint symbol Red course line made from trail Magenta new trail Cross track error range (off course indicator) Arrival alarm Navigate trail, navigation page (compass rose) views: Driver is heading north straight toward trail point 3 (left). Bearing arrow shows the bearing to the trail point is 355 degrees. Driver has reached trail point 3 (right), causing the Arrival alarm to go off. The unit now shows navigation information to point 4, which is 1. 42 miles away. Navigate a Back Trail 1. Press to enter the Saved Trail list, then use or to select the desired Trail Name|ENT. Press to REVERSE ROUTE|ENT| to NAVIGATE|ENT. The unit shows navigation information along the trail, in reverse. 51 NOTE: If you are already located at or near the end of your trail, the arrival alarm will go off as soon as you hit Enter. Just press EXIT to clear the alarm and proceed. Now, begin moving and allow the unit to guide you. When you reach your destination, be sure to cancel your navigation. [. . . ] Central Standard Time, M-F Eagle Electronics may find it necessary to change or end our shipping policies, regulations, and special offers at any time. We reserve the right to do so without notice. . . . in Canada: If you're in Canada and you have technical, return or repair questions, please contact the Factory Customer Service Department. Before any product can be returned, you must call customer service to determine if a return is necessary. Many times, customer service can resolve your problem over the phone without sending your product to the factory. [. . . ]