User manual EAGLE INTELLIMAP MACH 1

[. . . ] (See Figure 23) Align the two notches in the core with the tabs on the lower take-up spool. Slide a fresh roll of paper in position on the supplyside shaft on the right side of the platen assembly. The paper must spool off the bottom of the roll. Draw the end of the paper across the face of the platen, around the friction roller, over thetake-upcore, and tape it squarely to the take-up core. [. . . ] INITIAL TRANSMIT PULSE WIDTH (micro-seconds) 110 150 the range control is set to 300 feet, and the Suppressor control is rotated to the maximum clockwise position, thetransmitter pulse width would be 1100 microseconds. (300 initial pIus 800 equals 1100 micro-seconds. ) Paper Speed Control This knob adjuststhe speed of thechart paper. For good detailed graphs, in shallowto medium depths, turn the paper speed control up to at least ¾ when trolling. This will show proper fish arches at low speeds and keeps high speed information from being compressed. The paper speed should be turned down when using the unit in deep water. This will prevent gaps from appearing in the record. In fact, the microcomputer will automatically slow the maximum speed of the chart paper when operating in deep water. The chart below gives the points where the maximum speed of the paper is slowed. the take-upcore. Don't use oily cloths, strong solvents, Symptom or abrasive cleansers. TROUBLESHOOTING SECTION Recorded marks are very heavy; paper is torn by stylus. In other words, if gaps appear in the record, turn the paper speed down until a solid record is achieved. The paED bE ED ---------------------- ERDLE ED Figure 32 LINES"OFF" Figure 33 LINES "ON" 15 PDF compression, 6OCR, web-optimization with CVISION's PdfCompressor lines immediately. Turn the range control back to your original depth setting. To turn the lines back on, simply reverse the procedure by turning the range control to 10 feet, hold the marker switch "ON", and rotate the rnge control to the 20 feet position. Return the range control to the desired depth setting. Scale The numbers that indicate the depth or scale may be deleted if desired. Rotate the range control to the 60 feet position, hold the marker control "ON", and turn the range control to the 40 feet position. The depth scale will no longer be printed. The range control now may be turned to the desired depth setting. To turn the depth scale back on, rotate the range control to 40 feet, hold the marker switch "ON", and rotate the range control back to the 60 feet position. Remember, the marker switch must be on during the period of time that the range control is switched. Return the range control to the desired depth setting. Transmitand Print Alternate When using the MACH 1 in deep water, it may be desirable to slow the papersped down considerably. However, when doing so, you may get 'over print" or very dark, heavy printing over an area that is difficult to read. [. . . ] HOW IT WORKS this unit has, we have split the When the unit is turned on, an operation section of this manual into two sections. The first part, electronically regulated motor drives a lightweight belt located Section III, is entitled "Basic Opat the right edge of the rqcording eration" and covers everything that is absolutely necessary to paper. The marking stylus is attached to the belt. When the styuse your EAGLE in a wide variety lus is at the top of the paper a of situations. [. . . ]