User manual EAGLE INTELLIMAP 502 C IGPS INSTALLATION NOTES

[. . . ] 988-0152-141 www. eaglesonar. com Mapping GPS Receiver Installation and Operation Instructions Copyright © 2005 LEI-Eagle. No part of this manual may be copied, reproduced, republished, transmitted or distributed for any purpose, without prior written consent of Eagle Electronics. Any unauthorized commercial distribution of this manual is strictly prohibited. Eagle and IntelliMap are registered trademarks of LEI. [. . . ] Trail waypoint symbol Track or compass heading indicator Bearing arrow Cross track error range (off course indicator) Red course line made from trail Magenta new trail Arrival alarm Navigate trail, navigation page (compass rose) views: At left, driver is heading north straight toward trail point 2; bearing arrow shows the trail point is 357 degrees (straight ahead. ) At right, driver has reached trail point 2 and must turn northeast to follow the trail. Arrival alarm goes off and bearing arrow swings around to say turn right (east), toward the next waypoint, trail point 3. The unit now shows navigation information to point 3, which is 0. 40 miles away. Navigate a Back Trail (backtrack, or reverse) 1. Press || to enter the Saved Trail list, then use or to select the desired Trail Name|ENT. Press to DELETE TRAIL| to NAVIGATE|ENT. Press to REVERSE ROUTE|ENT| to NAVIGATE ROUTE|ENT. The unit begins showing navigation information along the trail, in reverse. NOTE: If you are already located at or near the end of your trail, the arrival alarm will go off as soon as you hit Enter. Just press EXIT to clear the alarm and proceed. When you reach your destination, be sure to cancel your navigation: press MENU|MENU| to CANCEL NAVIGATION|ENT. The unit asks if you're sure; press |ENT. Transfer Custom Maps and GPS Data Files Custom Maps: Custom maps work only from the MMC card or SD card. When a card containing a Custom Map File is loaded into the unit, the unit automatically loads the map into memory when the unit is turned on. Instructions for copying Custom Map Files to an MMC are contained in the instruction manual for your MMC card reader and MapCreate 6 software. For instructions on inserting an MMC into the unit, see Sec. NOTE: To load a Navionics chart, see Sec. GPS Data files: GPS Data Files contain waypoints, routes, trails and event marker icons. Instructions for copying GPS Data Files between your computer and an MMC are contained in the instruction manual for your MMC card reader and MapCreate 6 software. GPS data automatically recorded in the unit's internal memory must be saved to the MMC (as a GPS Data File) in order to store it on your personal computer. GPS Data Files stored on an MMC must be copied from the card to the unit's internal memory before the unit can read them. Press MENU|MENU| to SYSTEM SETUP|ENT| to TRANSFER MY DATA|ENT and the screen below appears. 51 The Transfer My Data submenu asks if you want to save data to the MMC or load data from the MMC into the unit's memory. 2. The Transfer My Data menu includes a message which tells you if an MMC is present or not. If no MMC is present, you must first insert a card into the unit in order to activate the Load or Save commands. [. . . ] Central Standard Time, M-F Eagle Electronics may find it necessary to change or end our shipping policies, regulations, and special offers at any time. We reserve the right to do so without notice. . . . in Canada: If you're in Canada and you have technical, return or repair questions, please contact the Factory Customer Service Department. Before any product can be returned, you must call customer service to determine if a return is necessary. Many times, customer service can resolve your problem over the phone without sending your product to the factory. [. . . ]