User manual EAGLE INTELLIMAP 642C IGPS INSTALLATION NOTES

[. . . ] 988-0152-161 www. eaglegps. com IntelliMap® 642c iGPS Mapping GPS Receiver Installation and Operation Instructions Copyright © 2005 LEI-Eagle All rights reserved. No part of this manual may be copied, reproduced, republished, transmitted or distributed for any purpose, without prior written consent of Eagle Electronics. Any unauthorized commercial distribution of this manual is strictly prohibited. Eagle® is a registered trademark of LEI. [. . . ] Press MENU|MENU| to CANCEL NAVIGATION|ENT. Press |ENT. Transfer Custom Maps and GPS Data Files Custom Maps: Custom maps work only from the MMC card or SD card. When a card containing a Custom Map File is loaded into the unit, the unit automatically loads the map into memory when the unit is turned on. Instructions for copying Custom Map Files to an MMC are contained in the instruction manual for your MMC card reader and MapCreate 6 software. For instructions on inserting an MMC into the unit, see Sec. GPS Data files: GPS Data Files contain waypoints, routes, trails and event marker icons. Instructions for copying GPS Data Files between your computer and an MMC are contained in the instruction manual for your MMC card reader and MapCreate 6 software. You must enter which way you want to transfer data, from an MMC card to the unit (load) or from the unit to an MMC card (save). GPS data automatically recorded in the unit's internal memory must be saved to the MMC (as a GPS Data File) in order to store it on your personal computer. GPS Data Files stored on an MMC must be copied from the card to the unit's internal memory before the unit can read them. Press MENU|MENU| to SYSTEM SETUP|ENT| to TRANSFER MY DATA|ENT. The Transfer My Data menu includes a message which tells you if an MMC is present or not. If no MMC is present, you must insert a card into the unit to activate the Load or Save commands. To transfer data from the unit to the MMC: press ENT (for SAVE. ) To transfer data from the MMC to the unit: press to LOAD|ENT. Saving to MMC: To accept the default name "Data" for the GPS Data File, press to SAVE DATA|ENT. If you want to rename the file (as shown in the following figures), press ENT to activate the selection box. Press to change the first character, then press to the next character and repeat until the name is correct. Then press ENT| to SAVE DATA|ENT. The unit will display first a progress then a completion message when the data transfer is finished. To return to the Page view, repeatedly press EXIT. These figures (from left to right) show the menu sequence for naming and saving a GPS Data File from the unit's memory to an MMC. 4. Loading to unit memory: There may be more than one GPS Data File (*. USR) on the card. To select a file, press ENT to activate the selection box, use to highlight the file, then press ENT to accept the selection. The unit will display a completion message when the data transfer is finished. To return to the main page display, press EXIT repeatedly. 51 Figure 1. Figure 2. Figure 3. Figure 4. These figures show the menu sequence for loading a GPS Data File from an MMC into the unit's memory. Cancel Navigation You can turn off any of the navigation commands after you reach your destination or at any other time by using the Cancel Navigation command. Press MENU|MENU| to CANCEL NAVIGATION|ENT| to YES|ENT. 52 Section 4: Advanced GPS Operations Find Distance Current Position to Another Location 1. [. . . ] We reserve the right to do so without notice. . . . in Canada: If you're in Canada and you have technical, return or repair questions, please contact the Factory Customer Service Department. Before any product can be returned, you must call customer service to determine if a return is necessary. Many times, customer service can resolve your problem over the phone without sending your product to the factory. To call us, use the following toll-free number: 800-661-3983 905-629-1614 (not toll-free) 8 a. m. [. . . ]