User manual EAGLE MAPGUIDE ADDENDUM

[. . . ] Map Guide TM INSTALLATION AND OPERATION INSTRUCTIONS Copyright © 1996, 1997, 1998 Eagle Electronics All rights reserved. Map GuideTM is a trademark of Eagle Electronics Eagle® is a registered trademark of Eagle Electronics WARNING!USE THIS UNIT ONLY AS AN AID TO NAVIGATION. A CAREFUL NAVIGATOR NEVER RELIES ON ONLY ONE METHOD TO OBTAIN POSITION INFORMATION. [. . . ] The default reference is waypoint number one. Highlight the "REFERENCE WPT" label on the Project WPT menu and press the right arrow key. Select a waypoint using either the waypoint number, or waypoint list. When you've chosen the waypoint, highlight the "SET REFERENCE" label and press the right arrow key. The unit returns to the Project WPT screen shown above. The starting waypoint you chose shows in the middle of this screen. Now set the distance from the starting waypoint to the projected waypoint by highlighting the "SET DIST" label and pressing the right arrow key. Use the arrow keys to set the distance, then press the ENT key when you're finished. The unit returns to the Project WPT screen. Now enter the bearing from the starting waypoint to the projected waypoint by selecting "SET BRG" from the Project WPT screen. Once you've entered the bearing, the unit returns to the Project WPT screen with the distance and bearing showing at the bottom of the screen, as shown at right. In this example, a distance of 2. 5 miles and a bearing of 50° was used. The unit saves the projected location under the waypoint number that you picked at the beginning. 30 SELECTING A WAYPOINT In order to edit or navigate to a waypoint, you must first select it. There are three ways to do this: by waypoint number, waypoint list, or search by name. All selection methods are on the main waypoint menu shown at right. Waypoint Number To select a waypoint by its number, simply highlight the "WPT" label at the top of the waypoint menu, then press the left or right arrow keys until the desired waypoint number appears. Waypoint List The waypoint number selection method forces you to scroll through all waypoint numbers, whether there's a location saved in them or not. The waypoint list is composed only of saved waypoints. To use the list, select "WPT LIST" from the waypoint menu. The names of all waypoints stored in memory show on this list. Simply highlight the desired waypoint and press the right arrow key to select it. (Note: When created, a waypoint is given a default name designated by an asterisk (*). [. . . ] Always use the original shipping container and filler material the product was packed in when shipping your product. 2 Always insure the parcel against damage or loss during shipment. Eagle does not assume responsibility for goods lost or damaged in transit. For proper testing, repair, and service, send a brief note with the product describing the problem. [. . . ]