User manual EAGLE SEACHARTER 502CDF IGPS ADDITIONAL INSTRUCTIONS

[. . . ] 988-0152-131 www. eaglesonar. com FishElite® 502c iGPS & SeaCharter®502cDF iGPS Fish-finding Sonars & Mapping GPS Installation and Operation Instructions Copyright © 2005 LEI-Eagle All rights reserved. No part of this manual may be copied, reproduced, republished, transmitted or distributed for any purpose, without prior written consent of Eagle Electronics. Any unauthorized commercial distribution of this manual is strictly prohibited. Eagle® is a registered trademark of LEI. [. . . ] The left side has five customizable digital data boxes containing: Water Depth, Water Temperature, Water Speed, Water Distance (distance traveled requires a speed sensor) and an air temperature sensor. The Depth box also shows settings for Shallow and Deep alarms. Digital Data. Customizing the Digital Data Screen The Digital Data screen can be customized to show digital data different from the defaults first shown. 74 Sonar Page Menu with Customize highlighted (left). Water Temp, the first customizable data box, begins flashing to show it is selected (right). 1. From the Digital Data sonar page, press MENU| to CUSTOMIZE|ENT. The Water Temperature box title bar flashes, indicating the box contents can be changed. Press ENT or select a different box and press ENT. Use to select a different type of data, then press ENT|EXIT|EXIT. The list first appears with Water Temperature selected (left). Maximum Speed has been picked to replace Water Temperature (right). Tip: You can customize other digital data boxes before returning to the Sonar Page. After changing the first box by selecting the Data Type and pressing ENT|EXIT, use to select another box to change. When the selected box title bar flashes, press ENT then to select data type|ENT|EXIT. Repeat these steps until you are satisfied with the settings. Press EXIT to return to the Sonar Page. 75 Map With Sonar Split Screen There is a page mode that splits the screen in half, with sonar on one side and mapping on the other. It can be found on the Pages Menu under the Map Page category. The Pages Menu with the Map option list (left). Active Map is listed at the top of the map page. Sonar is the active page, denoted by the blue bar at the top of the page. When this screen is displayed, you can switch back and forth between the two windows by activating the sonar or map window. "Active Map" will appear at the top of the map page when it is activated. Press PAGES|PAGES again and the bar at the top of the sonar page turns blue. Sonar Simulator This unit has a built-in simulator that lets you run it as if you were on the water. All sonar features and functions are useable. From the Sonar Page, press MENU|MENU| to SONAR SETUP|ENT| to SONAR SIMULATOR|ENT|ENT|EXIT. NOTE: If you turn on your unit before attaching a transducer, it may enter a demo mode. The words demo mode flash on the bottom of the screen and a sonar chart plays much like the simulator. [. . . ] We reserve the right to do so without notice. . . . in Canada: If you're in Canada and you have technical, return or repair questions, please contact the Factory Customer Service Department. Before any product can be returned, you must call customer service to determine if a return is necessary. Many times, customer service can resolve your problem over the phone without sending your product to the factory. To call us, use the following toll-free number: 800-661-3983 905-629-1614 (not toll-free) 8 a. m. [. . . ]