User manual EARLEX HEAT GUN HG 1500

[. . . ] . Do not allow the machine to become damp or be operated in damp conditions. . Poisonous or inflammable gases may be produced when working with paints (especially older type lead paints), varnishes, plastics and similar materials. . Never use the heat gun close to inflammable materials, heat may be conducted to combustible materials which are out of sight. . Ensure the heat gun switch is in the off position when connecting to the mains. [. . . ] Ensure you have the nozzle facing the correct way to deflect the heat away from the glass before you switch on. Rotate the gun or nozzle 90o as you move to horizontal or vertical bead. Allow nozzle to cool before attempting to turn it. Paint can be removed from profile surfaces by using a shavehook and/or a soft wire brush. Nozzles The gun is supplied with 2 different shaped nozzles, which can be used as follows. Concentrator Nozzle This nozzle directs a concentrated heat flow to the workpiece. It is ideal for use when removing paint in awkward corners, crevices, mouldings, beading, architrave's or whenever precise Concentrator Nozzle paint removal is required. WARNING:Glass can break easily Maintenance Always allow the machine to cool down and disconnect from power supply. The heat gun should be cleaned before being stored away by wiping over with a clean damp cloth; do not use any chemicals. Ensure that the ventilation slots are not blocked. Trouble Shooting If a problem occurs always switch the unit off immediately. Unit fails to work: Check the fuse in the plug is sound and rated 13amps. If an extension cable is used it must be fully unwound and rated at least 10amps capacity. 3 Glass Protection Nozzle This nozzle deflects the heat away from glass or other fragile areas and back onto the workpiece. Glass Protection Nozzle IF YOU REQUIRE FURTHER ASSISTANCE PLEASE CONTACT OUR HELPLINE NO. 01483 454666 Monday -Friday 08:30 -17:00 (Excluding Bank Holidays) MAINS CONNECTION Your unit has been supplied with a mains lead with a fitted moulded plug. This is identified by the fuse holder in the base of the plug. Please read the following safety instructions before use. If the moulded plug is cut off from the mains lead then the plug must be disposed of safely. NEVER under any circumstances insert such a plug into a 13 amp socket. NEVER under any circumstances use the appliance without the fuse cover fitted. This is the little cover fixed into the base of the plug to hold the fuse in place. If you lose the fuse cover then please contact any electrical dealer for a replacement or ring our helpline. A replacement fuse must be rated at 13amp. The fuse must be manufactured and approved to BS1362. IF IN ANY DOUBT PLEASE CONTACT AN ELECTRICIAN. If you need to fit a plug to the mains lead, this should be fitted in accordance with the wiring instructions as shown below, and will need to be used with a 13 amp fuse. [. . . ] Easy to use the PR9 provides enough capacity for one coat of a 3. 6m x 2. 7m (12' x 9') room without having to refill. ASG55 Super Sprayer - Sprays a 6'x6' fence panel in 3 minutes!55W Electric Airless Spray Gun, ideal for spraying wood preservatives, shed & fence treatments, water and solvent based paints. SG75-Super Sprayer 75- 85W Electric Airless Spray Gun. [. . . ]