User manual EARLEX SPRAY STATION 3500

[. . . ] Always disconnect unit from mains supply when filling the paint container. Always disconnect the Spray Station from the mains supply before cleaning the appliance. This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety. Warning: The use of any accessory or attachment, other than those recommended in this instruction manual, may present a risk of personal injury. [. . . ] Do not forget that the Paint Flow Adjuster controls the quantity of paint sprayed (Fig. Uncoil the air Hose and attach it to the back of the Spray Gun and the other end to the Spray Station. This will immediately cause some air to be produced, which is quite NORMAL. However, none of the product will be sprayed until the Spray Gun Trigger is pulled. Very important: when spraying for the first time, we recommend that you always leave the motor unit to run for 1 to 2 minutes before applying the product. Do not forget that the Paint Flow Adjuster controls the quantity of paint sprayed (Fig. The most commonly used technique for painting a large surface is the `crisscross' technique, i. You apply the product in a horizontal strips and then cross over these strips by applying the product in a vertical strips (Fig. 1) To achieve a horizontal strip adjust the Spray Direction Plate to the vertical position then pull the Trigger and move your arm across to the right. Round Spray Round for small and precise jobs 3) Next, to achieve a vertical strip adjust the Spray Direction Plate to the horizontal position then pull the Trigger and move your arm up and down over the horizontal strips you just have sprayed. 2) When you get to the end of the line, release the Trigger for a moment and then apply the product in the opposite direction just beneath the line you have sprayed. Through gradual movement of the Spray Direction Plate (4) between Horizontal, Vertical and Round spray pattern you can vary the width of the pattern (Fig. 3) HINT: To obtain the best results always keep your Spray Gun level and at an equal distance from the object you are spraying, ideally 25-30cm (10"-12") (Fig. Let your arm control the movement rather than your wrist (Fig. This will help give you an even paint distribution. HINT: HVLP technology produces warm air through the Air Cap allowing the paint to dry quicker which can enhance the final effect. HINT: For ceilings and floors make sure the Pick-up Tube is properly oriented towards the handle of the Spray Gun. Water based paint Oiled based paint HINT: When done immediately the cleaning operation can take you less than 5 minutes. If taking a break, leave the Spray Gun in a plastic bag to prevent the paint from drying. Pour any leftover paint into its container so that it can be used for the future. Pull the Trigger to allow paint to run out of the Pick-up Tube (11). Pour a quantity of the respective thinner into container, shake the Spray Gun lightly, reassemble the Spray Gun, then spray this liquid though the Spray Gun. [. . . ] GUARANTEE and HELPLINE This product is guaranteed for a period of 24 months against faulty manufacture or materials. it is not guaranteed for industrial or hire purposes. This guarantee does not affect your statutory rights. For further information or any user advice, please phone our helpline between 9am to 12pm and 2pm to 5pm Mondays to Fridays (excluding Bank Holidays), or visit our website www. [. . . ]