User manual EATON 3S 700VA 2P T

[. . . ] 5 6 7 8 UPS connections Connect the UPS 1 to the AC-power system via a wall outlet with an earth connector, using the attached cord for a UPS with FR/ DIN sockets or with the supply cord of your computer for a UPS with IEC sockets (see figure A). l Plug critical equipment (computer , monitor , modem , etc. ) into the outlets 6 providing battery backup power and surge protection (see figure B), taking care not to exceed the rated current indicated in amperes. l Other devices (printer , scanner , fax , etc. [. . . ] english Battery disposal and safety 8 7 l Caution. Battery service life is reduced by 50 % for every ten degrees above 25 °C. L The battery elements must be replaced exclusively by qualified personnel (risk of electrocution), with new elements approved by EATON to ensure correct operation of the UPS. L The battery must be disposed of in accordance with applicable regulations. To remove the battery elements, shut down the UPS (button 8 OFF), remove the power cord and proceed as indicated in page 4 "Battery change". L Battery charge: The UPS charges the battery as soon as it is connected to the AC outlet, whether button 8 is pressed or not. When used for the first time, the battery will only provide its maximum autonomy after it has been charged for 8 hours. It is recommended that the UPS be permanently connected to the AC power supply to ensure the best possible autonomy. L Switching-on the UPS: press button 8 for about 1 second. L Filtered outlets 5 without battery backup: Equipment connected to these outlets is supplied as soon as the AC cord is plugged in. L Battery backup outlets 6 : Equipment connected to these outlets is supplied as soon as button 8 turns green (see figure E). These outlets can be turned on even if the UPS is not connected to AC power (button 8 flashes). 6 614-09954-00 Troubleshooting (For further information, visit the powerquality. Com site or contact after-sales support) Problem 1 2 3 l Diagnostic l Solution l The connected devices are not supplied when AC power fails. L AC power is available, but the UPS operates on battery power. L The devices are not connected to the battery backup outlets 6 . L l Connect the devices to the battery backup outlets 6 . L Disconnect excess equipment and reset the circuit breaker 9 by pressing the corresponding button. Circuit breaker 9 , located under the UPS, has been tripped by an overload on the UPS output. 4 l The filtered outlets 5 are not supplied. [. . . ] 8 l The telephone line is disturbed or modem access is not possible. L Disconnect the telephone line from the wall outlet. 614-09954-00 7 English The battery backup outlets 6 are not supplied with power. L Press button 8 and check that it turns green. [. . . ]