User manual EBENCH KH 2074

[. . . ] Do not dismantle a surveillance camera or its components since there is a danger of an electric shock. only use the cables provided to connect the components. If liquid should penetrate the device, disconnect it from the power supply immediately to avoid the danger of a fire or an electric shock. [. . . ] Put the three parts of the wall bracket together (see Fig. Then mount the wall bracket onto a suitable wall using the fastening material included; place the camera on the set screw at the top end of the bracket and tighten it using the knurled screw (see Fig. Fix the camera in the required position using the wing screw. Now connect the power supply cable to the power cable of the mains adapter and then insert this in a mains socket. Connect the receiver to a television set using the SCART-cable, connect the power supply cable of the mains adapter to the receiver and insert the mains adapter in a socket. When the receiver is switched on, a red control LED lights up on the front, showing the device is ready for operation. Note: Outside, the transmission range of the camera is up to 100 metres, inside buildings it depends to a great extent on the construction materials used. Tip: If your television set only has one SCART connection and you would like to operate other devices with it besides your new eBench surveillance camera (video recorder, DVD player etc. ), you can connect the receiver of your surveillance camera system between video recorder or DVD player and television set. To do this, connect the receiver SCART-cable to the television set and the video recorder or DVD player to the receiver per SCART-cable. When the receiver is switched on, the signal of the camera will be received, interrupting the signal of the video recorder or DVD player. When the receiver is switched off, the television set will receive the AV signal again. Once you have connected all the components together, camera and receiver must now be set to the same channel. Remove the rubber cover from over the channel selection switch on the back of the camera. Choose the required channel by sliding the required switch to ON on the back of the device (see Figure ). the receiver receives signals from up to four cameras. If you have selected channel 1 for the first camera, you must select channels 2-4 respectively for the other cameras. If several cameras are in operation, you can use the "T" switch on the back of the receiver to change the interval at which the receiver changes channels (4 or 8 seconds), i. [. . . ] b) Reduce the distance between the camera and the receiver. Outside, the radio transmission range is up to 100 metres, inside buildings it depends to a great extent on the construction materials used. C) If a microwave or other electromagnetic device is in operation, switch it off and check your surveillance system again. [. . . ]