User manual EBENCH KH 2254

[. . . ] 6 CD CLOCK RADIO KH 2254 CD CLOCK RADIO Operating instructions KOMPERNASS GMBH · BURGSTRASSE 21 · D-44867 BOCHUM www. kompernass. com ID-Nr. : KH2254-02/08-V2 KH 2254 q 2# 2@ 2!2) ; l k j h g f d s a w e t r y u i o 2$ 2% 2^ 2& 2* 2( 3) 3!3@ 2$ INDEX Intended Usage Technical data Safety information Operating Elements Commissioning PAGE 2 2 2 4 5 Providing mains power . . 5 Battery Back-up System in Case of Power Failures . [. . . ] If possible place an anti-slip material under the feet of the appliance. Danger - Laser Beams! The appliance is fitted with a "Class 1 Laser". · · · Never open the device. There is invisible laser radiation inside the device. Avoid all direct optical contact with the laser beam, it could lead to serious eye injuries. -4- Commissioning Unpack the appliance Remove all packing material. Remove also the transportation lock from the CD compartment. Battery Back-up System in Case of Power Failures The battery ensures that the clock continues to function in the event of a power failure. To prolong the life, however, the time is not shown in the display. If a battery is not inserted, after a power failure 12:00 appears on the display. This means that you have to carry out the time and alarm settings again. Attention! Do not permit small children to play with the plastic packaging. There is a risk of suffocation! Setting the Time For setting the time, the appliance must be switched off with the button ON/OFF u. Check the items supplied Whilst unpacking, check to ensure that all of the following items are available: · World Receiver · Connector power pack · Operating Instructions with Warranty Card Setting the time when switching on for the first time: · Hold the button TIME r pressed down to switch between the 12h or 24h mode. Take note: Providing mains power This CD clock radio is operated with 230 - 240 Volt alternating current (AC), 50 Hz. It is additionally equipped with a back-up system for use in the event of a power failure, for which a 9 V block battery (not supplied) is required to be inserted. · Connect the plug of the power pack with a wall power socket (AC). · Insert the 9 V block battery into the battery compartment 3) on the underside of the appliance. In the display appears "12h" for the 12 hour mode resp. For the afternoon hours, an additional LED showing "PM" now appears at the top left of the display. Using the buttons SKIP/SEARCH MIN and SKIP/SEARCH HR w programme in the desired time. · When you re-press the button TIME r the programming is saved. The time display no longer flashes. Take note: The use of an alkaline battery is recommended. In order to ensure optimum functioning, the battery should be changed every 6 months. Batteries are not charged in the battery compartment! Setting the time at some later point: · Hold the button TIME r pressed down to switch between the 12h or 24h mode. Using the buttons SKIP/SEARCH MIN and SKIP/SEARCH HR w programme in the desired time. · When you re-press the button TIME r the programming is saved. The time display no longer flashes. -5- Radio operation 1. Slide the function selector switch 3! [. . . ] NEVER use moisture to clean the inside of the CD compartment! · Sleep timer · Slide the function selector switch 3!to CD or RADIO. · After you have pressed the button SLEEP l, "90" appears in the display. · Press the button SLEEP l again to set the desired sleep time (90, 60, 30 or 15 minutes). The sleep time countdown starts after a few seconds. [. . . ]