User manual EBODE IR LINK FLUSH

[. . . ] No guarantee or liability will be accepted for any damage caused due to incorrect use of the equipment supplied, other than indicated in this owner’s manual. SAFETY WARNINGS • • • • To prevent short circuits, this product (except if specified for outdoor use) should only be used inside and only in dry spaces. Do not expose the components to rain or humidity. [. . . ] The ebode IR Link Pro Flush is intended for use in IR control systems where the IRHUB4 Connecting Hub is within reach of the 2-meter cable of the IRLPRO IR Receiver, e. When installing the IR Link Pro Flush Kit in a cabinet where the controlled components are behind closed doors, and the IRLPRO Flush Receiver can i. Be mounted into the cabinet (see step 3 in chapter 5), but always within line of sight of your hand held remotes. Installing the ebode IR Link Pro Flush The IRHUB4 sockets are colour coded for easy plug & play installation of the IR Receiver and IRED Emitters, which have coloured jacks. Refer to this diagram and the procedure that follows when making connections: Fig 1 31-12-2010 4 IR Link Pro Flush 1. Attach the 3IREDB Emitters onto the IR Sensor Windows of the components in your system that you wish to control. Plug the yellow mini plugs of the 3IREDB into one of the yellow labelled "EMITTERS" jacks of the IRHUB4 Connecting Hub. Plug the IRQC cable into one of the yellow labelled “EMITTERS” jacks of the IRHUB4, and the other side into the 3. Drill a hole 10, 5 mm wide where you wish to position the IR Receiver. Remove the screw-nut, push the receiver cable and thread through the hole with the lens facing into the room (and in line-of-sight of your handheld remote). Screw the nut back on until tight to hold the IR Receiver in place. Plug the red mini-plug of the IRLPRO Flush IR Receiver into the red labelled "IR RCVR" jack on the IRHUB4 Connecting Hub. Plug the 12VDC Power Supply into an unswitched 230V~50Hz outlet. NOTE: It is important that you use an unswitched AC outlet so that the IR system is always active for system power ON commands. 1mm "C" plug of the Power Supply Adapter into the "+12VDC" jack on the IRHUB4 Connecting Hub. STATUS You can send a Power Status signal to the IRLPRO Flush IR Receiver by connecting a power adapter to this connection (not supplied; 5 - 24VDC & 5 – 12VAC), which e. When the A/V device or contact is switched on, the Amber Status LED will light up in the IRLPRO Flush IR Receiver so that you can see that the A/V device is switched on. Fig 2 Fig 3 31-12-2010 5 IR Link Pro Flush On the top of the cabinet there is a cut out for jumper placement. [. . . ] Upp till sex IRLPRO Flush IR-mottagare kan anslutas parallellt till skruvterminalingångarna på IR Link IRHUB-seriens anslutningsmoduler (t. Kabelspecifikationer för längre kabel till angränsande rum: 3-ledare, 24AWG/0, 2 mm 2 solid eller platt kabel upp till 50 m, 22AWG/0, 35 mm2 upp till 100 m, 20AWG/0, 5 mm2 upp till 200 m och 18AWG/1 mm2 upp till 300 m (oskyddad OK). User Information for Consumer Products Covered by EU Directive 2002/96/EC on Waste Electric and Electronic Equipment (WEEE) This document contains important information for users with regards to the proper disposal and recycling of ebode products. [. . . ]