User manual ECHO PB-200

[. . . ] Keep it in a safe place for future reference. It contains specifications and information for operation, starting, stopping, maintenance, storage and assembly specific to this product. table of contents Introduction . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2 - The Operator's Manual . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2 Safety . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3 - Manual Safety Symbols and Important Information . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3 - International Symbols . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3 - Personal Condition and Safety Equipment . . . . . . . . . 3 - Equipment Check. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 6 Emission Control . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 6 Description . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 7 Contents . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 8 Assembly. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 9 - Blower Application . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 9 Operation. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 9 - Fuel . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 9 - Starting Cold Engine. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 11 - Starting Warm Engine . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 12 - Stopping Engine. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 12 - Operating Blower. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 13 Maintenance . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 14 - Skill Levels . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] Fill an approved fuel container with half of the required amount of gasoline. Add the proper amount of 2-stroke oil to gasoline. Close container and shake to mix oil with gasoline. Add remaining gasoline, close fuel container, and remix. Shoulder level Fuel tank Power Blower oPerator's Manual startInG cold enGIne · Provide all operators of this equipment with the Operator's Manual and instructions for safe operation. · Before starting the unit, equip yourself and any other person working within the 15 m (50 ft. ) Safety Zone with the required Protective Equipment and clothing. Stop Switch Move stop switch button (A) away from the STOP position. Throttle Position Move throttle position lever (B) midway between idle and full throttle positions. B 11 A 3. Choke Move choke (C) to "Cold Start" ( ) Position. C 4. Purge Bulb Pump purge bulb (D) until fuel is visible and flows freely in the clear fuel tank return line. Pump bulb an additional 4 or 5 times. IMPORTANT Recoil starter: Use short pulls - only 1/2-2/3 of rope for starting. Recoil Starter Place the unit on a flat, clear area. Firmly grasp throttle grip with left hand and rapidly pull recoil starter handle/rope (E) until engine fires (5 pulls maximum). Choke After engine fires (or 5 pulls), move choke lever to "Run" ( ) position and pull starter handle/rope until engine starts and runs. 5. NOTE Never use a higher speed setting than necessary to perform a task. Remember, the higher the engine speed, the louder the blower noise. Minimize dust by using blower at lower speeds. Be Smart - be a good neighbor. 14 maIntenance Moving parts can amputate fingers or cause severe injuries. Keep hands, clothing and loose objects away from all openings. Always stop engine, disconnect spark plug, and make sure all moving parts have come to a complete stop before removing obstructions, clearing debris, or servicing unit. Allow unit to cool before performing service. Wear gloves to protect hands from sharp edges and hot surfaces. Your ECHO blower is designed to provide many hours of trouble free service. Regular scheduled maintenance will help your blower achieve that goal. If you are unsure or are not equipped with the necessary tools, you may want to take your unit to an ECHO Service Dealer for maintenance. [. . . ] Pull the recoil handle slowly until the piston reaches the top of its travel and leave it there. 8. 9. Install the spark plug (do not connect ignition cable). Remove blower pipe assembly from unit. 22 specIfIcatIons MODEL ---------------------------------------------------- PB-200 Hand Held Length ------------------------------------------------------ 330 mm (13. 0 in. ) (w/o pipes) Width -------------------------------------------------------- 215 mm (8. 5 in. ) Height ------------------------------------------------------- 340 mm (13. 4 in. ) Weight (dry) ------------------------------------------------ 3. 8 kg (8. 38 lb. ) Engine Type ------------------------------------------------ Air cooled, two-stroke, single cylinder gasoline engine Displacement ----------------------------------------------- 21. 2 cc (1. 39 cu. in. ) Bore ---------------------------------------------------------- 32. 2 mm (1. 27 in. ) Stroke -------------------------------------------------------- 26. 0 mm (1. 10 in. ) Carburetor--------------------------------------------------- Zama w/primer bulb Ignition System -------------------------------------------- Flywheel Magneto, capacitor discharge ignition type Spark Plug -------------------------------------------------- NGK BPM-8Y Gap 0. 65 mm (0. 026 in. ) Exhaust System -------------------------------------------- Spark arrestor - catalytic muffler / muffler Fuel ---------------------------------------------------------- Mixed (Gasoline and Two-stroke Oil) Fuel/Oil Ratio ---------------------------------------------- 50 : 1 Power Blend X TM ISO-L-EGD (ISO/CD 13738) and J. A. S. O. [. . . ]