User manual ECHO SRM-230

[. . . ] Grass Trimmer/Brush Cutter Operator's Manual MODEL SRM - 230 SRM - 230S Read rules for safe operation and instructions carefully. ECHO provides an Operator's Manual and a Safety Manual. Both must be read and understood for proper and safe operation. WARNING X7532098204 X753002744 12/10 2 IntroductIon Welcome to the ECHO family. This ECHO product was designed and manufactured to provide long life and on-the-job dependability. [. . . ] This prevents dirt from entering the carburetor throat when the air filter is removed. Brush accumulated dirt from air cleaner area. Remove air filter and lightly brush debris from filter. Replace filter if it is damaged, fuel soaked, very dirty, or the rubber sealing edges are deformed. If filter can be reused, be certain it: · Fits tightly in the air filter cavity. · Is installed with the original side out. Tools Required: 200-250 mm (8 -10 in. ) length of wire with one end bent into a hook, clean rag, funnel, and an approved fuel container. Parts Required: REPOWERTM AIR & FUEL FILTER KIT. Fuel is VERy flammable. Use extreme care when mixing, storing or handling. Use a clean rag to remove loose dirt from around fuel cap and empty fuel tank. Use the "fuel line hook" to pull the fuel line and filter from the tank. Remove the filter from the line and install the new filter. DANGER 20 spark plug Level 2. Tools Required: T-Wrench, feeler gauge, soft metal brush. Parts Required: REPOWERTM Tune-Up Kit IMPORTANT Use only NGK BPM-8Y spark plug (BPMR-8Y in Canada) otherwise severe engine damage may occur. Remove spark plug and check for fouling, worn and rounded center electrode. Clean the plug or replace with a new one. Adjust spark plug gap by bending outer electrode. Tighten spark plug to 150-170 kg/cm (130-150 in. lb. ). 0. 65 mm (0. 026 in. ) coolIng system Level 2. Tools Required: 4 mm Hex Wrench, cleaning brush, 25 or 50 mm (1 or 2 in. ) Parts Required: None if you are careful. IMPORTANT To maintain proper engine operating temperatures, cooling air must pass freely through the cylinder fin area. This flow of air carries combustion heat away from the engine. Overheating and engine seizure can occur when: · Air intakes are blocked, preventing cooling air from reaching the cylinder. [. . . ] Any such part repaired or replaced under warranty will be warranted for the remaining ECHO Inc. Any emission related part scheduled for replacement during "required maintenance" is warranted for the period of time prior to the first scheduled replacement point for that part. Any such part repaired or replaced under warranty shall be warranted for the remainder of the period prior to the first scheduled replacement point for that part. Any manufacturer-approved replacement part may be used in the performance of any warranty maintenance or repairs on emission related parts, and must be provided without charge if the part is still under warranty. [. . . ]